05 Ranger STX 2wd clunk/clack under load
#1
Join Date: Sep 2008
Location: Florence, Ky
Posts: 49
Likes: 0
Received 0 Likes
on
0 Posts
05 Ranger STX 2wd clunk/clack under load
From a dead stop, stabbing the throttle results in a clack-clack-clack noise from the rear of the truck. Anyone experience this before? I'm thinking either drive-shaft or rear axle. Truck has 115K on it.
There is no play in the drive-shaft when you grab it and turn it by hand. None what so ever. There is also no vibration at any speed which would normally indicate u-joint failure. All heat shields are firmly in place too.
Please advise
Thanks,
Bob
There is no play in the drive-shaft when you grab it and turn it by hand. None what so ever. There is also no vibration at any speed which would normally indicate u-joint failure. All heat shields are firmly in place too.
Please advise
Thanks,
Bob
Thread
Thread Starter
Forum
Replies
Last Post
93rangerbamaboy
SOHC - 2.3L & 2.5L Lima Engines
1
01-15-2014 04:37 PM
danmm7
4.0L OHV & SOHC V6 Tech
5
11-06-2011 02:18 PM