1997 turn signals don't work but hazards do
#1
1997 turn signals don't work but hazards do
I have a 1997 ranger and my turn signals stopped working on the outside and the inside. But my hazards still do work. it was blinking really fast and then just stopped. What would that be?
Last edited by cjmcdonald169@gmail.com; 11-30-2015 at 11:10 AM.
#2
RF Veteran
iTrader: (1)
#4
RF Veteran
iTrader: (1)
#6
Hmm. I'm more familiar with 4th and early 5th gen (03 and before) but it may be possible that your multifunction switch itself is bad, or going out.
Although it may seem obvious, I'd take a moment to check the bulbs. Also check any fuses you have.
Typically when it's flashing really quick that means you have a bulb out. However given the fact it's intermittent I doubt that's the issue. It may also be worth checking the sockets for said bulbs too.
Good luck on your hunt.
Although it may seem obvious, I'd take a moment to check the bulbs. Also check any fuses you have.
Typically when it's flashing really quick that means you have a bulb out. However given the fact it's intermittent I doubt that's the issue. It may also be worth checking the sockets for said bulbs too.
Good luck on your hunt.
Thread
Thread Starter
Forum
Replies
Last Post
jay398
General Technical & Electrical
14
10-18-2017 08:08 AM
kappesdeb
General Technical & Electrical
0
07-17-2014 11:45 AM
Gloveman3
General Ford Ranger Discussion
2
08-25-2013 12:07 PM
DSMissed
General Ford Ranger Discussion
14
12-26-2009 01:54 PM