Another manual to power door question
#1
Another manual to power door question
Brand new to the board and have already read several threads about going from manual locks and windows to power, but nothing covered the question I have (at least not that I found). I was wondering if I could swap the whole driver's and passenger's doors from an 02 extended cab Ranger to my 02 standard cab XLT. Everything works and is included and I can get the doors for $50 each. I'm not even sure the doors will interchange, let alone whether the power can be hooked up. Any help would be greatly appreciated!!
#2
RF Veteran
iTrader: (1)
Yes, 1995 to 2005 doors are the same, regular or extended cab.
Powering up as a different matter, there are a few relays and the GEM needs to be reprogrammed for power windows, but.............
If you don't need "one touch down" you can 'short wire' it, still need to fuse it and connect doors together.
Diagram here
Powering up as a different matter, there are a few relays and the GEM needs to be reprogrammed for power windows, but.............
If you don't need "one touch down" you can 'short wire' it, still need to fuse it and connect doors together.
Diagram here
Thread
Thread Starter
Forum
Replies
Last Post
raccoon
General Technical & Electrical
0
01-28-2017 06:37 AM
Lefty04LevelII
General Technical & Electrical
1
07-05-2016 02:48 PM
04blackedge
OLD - Interior, Exterior, Electrical, & Misc.
1
05-07-2009 04:43 PM