Need a new pretensioner (seat belt clip thing)
#1
Join Date: May 2005
Location: Jackson, New Jersey
Posts: 4,872
Likes: 0
Received 0 Likes
on
0 Posts
Need a new pretensioner (seat belt clip thing)
I've been working out my problems with my air bag codes... slowly. I've replaced my RCM, fixed my passenger side air bag, now its giving me a 4-6, which means a problem with the passenger pretensiononer. I've unplugged it, and plugged it back in, also I've cleaned the contacts, but neither of those has worked. I'm to the point where I think the only thing I can do is get another pretensioner and try that.
If there's anybody on here that has the driver and/or passenger side pretensioners and would like to get rid of them, send me a private message. Or, if anybody can direct me to a website where I can find these, let me know. My searches haven't found me anything.
If there's anybody on here that has the driver and/or passenger side pretensioners and would like to get rid of them, send me a private message. Or, if anybody can direct me to a website where I can find these, let me know. My searches haven't found me anything.
#2
By pretensioner, do you mean the connection directly under the seat? If so -- I am having the same problems, code keeps popping up for the 4-7 and no matter how often I unplug it and put it back together, it just keeps popping back. Might like to see if anyone has any otehr viable fixes otehr then some di-electric and trying to get a clean connection.
Nothing more annoying then an orange blinking light in the darn dash *grr*
Nothing more annoying then an orange blinking light in the darn dash *grr*
#3
Join Date: May 2005
Location: Jackson, New Jersey
Posts: 4,872
Likes: 0
Received 0 Likes
on
0 Posts
Actually, I mean the whole part... that plug, the wiring, and also the part the seatbelt plugs into.
I can't pass NJ inspection with the light blinking. Even if I take the light out, it doesn't matter, because the inspection station still reads it through the damn OBD port. I can't clear the code with my tuner either.
I can't pass NJ inspection with the light blinking. Even if I take the light out, it doesn't matter, because the inspection station still reads it through the damn OBD port. I can't clear the code with my tuner either.
#5
#9
Thread
Thread Starter
Forum
Replies
Last Post
skulldoc
General Technical & Electrical
4
07-29-2014 09:30 PM
conundrum
General Technical & Electrical
7
05-13-2012 08:17 PM
winks
General Technical & Electrical
2
07-10-2008 06:31 AM
rngprerunner
General Technical & Electrical
20
02-20-2006 09:01 PM