ABS problem
#1
ABS problem
I have a problem with my ABS system. I searched through the other forums and couldnt find a thread that was the same but i figured someone might be able to help me out.
I recently replaced the rotors and pads and immediately after i repacked the bearings, put in new bearing seals, and torqued the bearing nut (hanes manual specs) the light came on as soon as i drove it down the street. Occasionally the light will go off and the brakes will make a grinding noise when i hit the breaks and the light will eventually go on and it will stop somewhat normally with the light on.
I took the rotors and bearings off again and retorqued them again and same problem. I even cleaned up the ABS sensors. I am wondering why the ABS started acting up as soon as i did it so i dont think it is a sensor, but who knows. Any input is appreciated. -03 ranger edge 2wd (i also upgraded to ceramic pads and powerslot rotors if that makes any difference) thanks!
IMG_0286.jpg?t=1243986239
IMG_0288.jpg?t=1243986339
I recently replaced the rotors and pads and immediately after i repacked the bearings, put in new bearing seals, and torqued the bearing nut (hanes manual specs) the light came on as soon as i drove it down the street. Occasionally the light will go off and the brakes will make a grinding noise when i hit the breaks and the light will eventually go on and it will stop somewhat normally with the light on.
I took the rotors and bearings off again and retorqued them again and same problem. I even cleaned up the ABS sensors. I am wondering why the ABS started acting up as soon as i did it so i dont think it is a sensor, but who knows. Any input is appreciated. -03 ranger edge 2wd (i also upgraded to ceramic pads and powerslot rotors if that makes any difference) thanks!
IMG_0286.jpg?t=1243986239
IMG_0288.jpg?t=1243986339
#2
#3
Thread
Thread Starter
Forum
Replies
Last Post
Trevelyn1015
General Technical & Electrical
27
09-12-2006 08:03 PM