Fog light conversion
#1
Fog light conversion
Has anyone seen this kit before or used it? just wondering how good it is. Also I have a broken foglight lens. Anyone know how much for a replacement? Or do I need to get a whole new light? thanx!
http://cgi.ebay.com/ebaymotors/01-06...66095664QQrdZ1
http://cgi.ebay.com/ebaymotors/01-06...66095664QQrdZ1
#3
Originally Posted by Kdog03
Has anyone seen this kit before or used it? just wondering how good it is. http://cgi.ebay.com/ebaymotors/01-06...66095664QQrdZ1
Pull the correct relay from the underhood distribution box.
Choose the correct blade and bend it over as shown.
Reinstall.
Works on 2001~2003 Rangers with factory foglamps
#5
#11
Originally Posted by franger
would this same procedure work with my 99 ranger 3.0 4x4 offroad?
mike
mike
1999~2000 Ranger foglamp mod:
Open the distribution box
Locate the foglamp relay at the rear corner of the box closest to the DS fender
(#10 in the owners manual)
Remove the relay and bend the correct pin as shown. Reinstall.
Map of Distribution Box. The red arrow shows relay #10.
Open the distribution box
Locate the foglamp relay at the rear corner of the box closest to the DS fender
(#10 in the owners manual)
Remove the relay and bend the correct pin as shown. Reinstall.
Map of Distribution Box. The red arrow shows relay #10.
#13
Originally Posted by armin922
so doing this wont mess anything up at all?
Just be careful if you also have aux driving lights. Most state laws say that you can't have more than 4 forward facing lights on at a time. Headlights + driving lights + fog lamps = 6. Some police will ticket for more than 4.
#16
On an 07, is it just that easy as bending a pin, or do you have to follow the how-to section and tap into the wire as described?
Yeah, about the question I JUST asked, completely disregard as I read another post and it says for 04 +, so that's where I would fall. Sometimes I wonder about myself...
Yeah, about the question I JUST asked, completely disregard as I read another post and it says for 04 +, so that's where I would fall. Sometimes I wonder about myself...
Last edited by user 92702; 01-27-2007 at 11:06 PM. Reason: I
#17
#18
Originally Posted by edgeaholic (tm)
instead of having a bent pin on your relay, couldn't you just bend it back and forth until the pin weakened and just snapped off, leaving a cleaner, more easier to re-install look?
#19
Originally Posted by LilRed
On an 07, is it just that easy as bending a pin, or do you have to follow the how-to section and tap into the wire as described?
#22
Originally Posted by LilRed
When you get a chance to look at the schematics, please post. It would be nice to be able to have the fogs on at the same time as the high beams.
#24