2004 Instrument Cluster Bulb Sizes?
#1
#2
Join Date: Apr 2007
Location: Placentia, CA
Posts: 927
Likes: 0
Received 0 Likes
on
0 Posts
Always make sure to do some searching or check out the DIY section before asking a question. But here you go, full write up for how to replace your burnt out bulbs...
https://www.ranger-forums.com/interi...-lights-65263/
https://www.ranger-forums.com/interi...-lights-65263/
#4
Always make sure to do some searching or check out the DIY section before asking a question. But here you go, full write up for how to replace your burnt out bulbs...
https://www.ranger-forums.com/interi...-lights-65263/
https://www.ranger-forums.com/interi...-lights-65263/
#6
Join Date: Apr 2007
Location: Placentia, CA
Posts: 927
Likes: 0
Received 0 Likes
on
0 Posts
In any case, the main bulbs that light up the cluster are 194s, and the bulbs for the service lights (check engine, 4x4, etc...) are 74. This covers years 1999-2005
#8
I got LED strips and soldered them in. I should have taken pictures of the install, but I didn't feel like it, haha. I got them from superbrightleds.com . It's the WFLS series flexible light strip... the 39" strip with 60 led's. It was just enough to do it. I might have to pull it back out to flip a bulb around (polarity is wrong) so I might take pictures.
http://www.superbrightleds.com/cgi-b...-flexible.html
Also got T1.5 series LED Twist Lock Lamps from superbrightleds.com . These also fit in your HVAC.
http://www.superbrightleds.com/cgi-b...nstrument.html
For the cruise control pods... I ordered these. You will need 5.
3528 Surface Mount PLCC-2 SMT LEDs
EDIT: Straight out of my build thread.. But basically you have 194 bulbs. You can replace with LED's or just get stock bulbs.. up to you.
http://www.superbrightleds.com/cgi-b...-flexible.html
Also got T1.5 series LED Twist Lock Lamps from superbrightleds.com . These also fit in your HVAC.
http://www.superbrightleds.com/cgi-b...nstrument.html
For the cruise control pods... I ordered these. You will need 5.
3528 Surface Mount PLCC-2 SMT LEDs
EDIT: Straight out of my build thread.. But basically you have 194 bulbs. You can replace with LED's or just get stock bulbs.. up to you.
#12
#15
Success!
Hello,
The bulbs were in fact the Sylvania 2721's. I bought 8 of them using a discount coupon at Advance Auto. The installation was very simple and straight forward. Just follow the steps posted on this forum, and the new bulbs are in in no time. The main thing to be careful with is tracking where all of the 7mm and 8mm screws are kept :)
BB
The bulbs were in fact the Sylvania 2721's. I bought 8 of them using a discount coupon at Advance Auto. The installation was very simple and straight forward. Just follow the steps posted on this forum, and the new bulbs are in in no time. The main thing to be careful with is tracking where all of the 7mm and 8mm screws are kept :)
BB
Thread
Thread Starter
Forum
Replies
Last Post
whiteflash13
General Technical & Electrical
3
01-19-2011 06:24 AM