Add on Tach for 2000 Ranger
#1
Add on Tach for 2000 Ranger
First post, and I know there is a hundred of these topics, ive searched already. And I know everyone here says switch clusters. Well I just want to add a tach on, but cant seem to find the signal wire "Inside" the dash
I have a 2000 xlt 3.0 distributorless.
I have a autometer tach, set for 6cyl already. I have my gauge cluster removed, but not sure where the signal wire is? I hear its a tan/yellow. But I want to be sure it works for my year. Because I seen a few diagrams for 2000 only says, "TACHOMETER - TAN/WHITE - Location: Ignition Coil" Also, if anyone has a picture where its located?
Thanks!
I have a 2000 xlt 3.0 distributorless.
I have a autometer tach, set for 6cyl already. I have my gauge cluster removed, but not sure where the signal wire is? I hear its a tan/yellow. But I want to be sure it works for my year. Because I seen a few diagrams for 2000 only says, "TACHOMETER - TAN/WHITE - Location: Ignition Coil" Also, if anyone has a picture where its located?
Thanks!
Last edited by evilbmxer; 02-24-2012 at 05:14 PM.
#2
#3
Thanks for the confirmation!
Its almost all setup! I figured it was pin 15 on clip C214 but I just wanted to make sure. I just wired the power and lights to the dimmer switch, and the ground to the metal plate under the steering column. Works good so far, Havent taken the truck out to see how accurate it is though. (Used gauge)
Its almost all setup! I figured it was pin 15 on clip C214 but I just wanted to make sure. I just wired the power and lights to the dimmer switch, and the ground to the metal plate under the steering column. Works good so far, Havent taken the truck out to see how accurate it is though. (Used gauge)
Thread
Thread Starter
Forum
Replies
Last Post
ranger64
General Technical & Electrical
1
07-03-2014 12:28 AM
01xltranger4x4
General Technical & Electrical
16
02-03-2006 11:53 PM
TippnOver
General Technical & Electrical
9
12-25-2005 07:01 AM