HID help
#1
HID help
I installed my HIDs last week (sorry no pics yet) when i turn them on they flash go blank warm up and comeback to normal do i have something hooked up wrong? also the little blue thing that plugs into the stock headlight plug you have to put 3 wires into it if i hooked the wire for the highbeams and lowbeams up backward would my lights still work i cant tell much difference between highs and lows here is the kits im running
ddm apexicon raptors 55w 9007 Hi/lows 6000k bulbs
ddm apexicon raptors 55w 9007 Hi/lows 6000k bulbs
#2
theyre supposed to 'flash', get dim, then slowly work themselves up to power. this happens when the bulbs are cold...totally normal.
use a test light to figure out which stock wire is high beam and which is low. in my how-to, I use a single beam so the empty spot in the pics would be the high beam.
everything asked is covered in my how-to.
use a test light to figure out which stock wire is high beam and which is low. in my how-to, I use a single beam so the empty spot in the pics would be the high beam.
everything asked is covered in my how-to.
#3
#4
Yes the flickering is totally normal. Now if they flicker after being turned on for a while, either you have a bad ground or the ballast is bad.
You should have to adjustment bolts on your housings, one going up and one sideways. Tighten/loosen them to move the lights up and down as well as left and right slightly.
You should have to adjustment bolts on your housings, one going up and one sideways. Tighten/loosen them to move the lights up and down as well as left and right slightly.
Thread
Thread Starter
Forum
Replies
Last Post
Want to Buy: 9005 HID kit and 9007 HID kit
Police Interceptor
OLD - Interior, Exterior, Electrical, & Misc.
0
12-14-2010 02:04 PM
edgerider2002
OLD - Interior, Exterior, Electrical, & Misc.
10
03-23-2010 09:42 AM