Rear Bumper Replacement
#1
Rear Bumper Replacement
Hi I recently got rear ended and will be replacing my rear bumper soon. I have a couple of questions though and hope ya'll can answer them.
1. Is there anything holding the bumper on besides the for nuts which can be seen from its underside
2. What year model bumpers would match mine
3. Does anyone know of any good pick and pulls around the upstate of SC
2004 4x2 xls step side 3.0
Thanks!
1. Is there anything holding the bumper on besides the for nuts which can be seen from its underside
2. What year model bumpers would match mine
3. Does anyone know of any good pick and pulls around the upstate of SC
2004 4x2 xls step side 3.0
Thanks!
#2
What year Ranger? I don't think it matters though. My 2000 bumper is held on with the 4 bolts you mention. Depending on the road conditions (salt in winter?), they may be a bit rusty and hard to remove, so use some PB Blaster or simular penitrant the night before.
Also don't forget to disconnect the license plate lights before you remove the bumper!
Also don't forget to disconnect the license plate lights before you remove the bumper!
#4
Thread
Thread Starter
Forum
Replies
Last Post
BlackRanger04
OLD - Interior, Exterior, Electrical, & Misc.
10
12-11-2010 05:26 PM