General Technical & Electrical General technical and electrical discussion for the Ford Ranger that does not fit in any other sub-forum.

Speakers shutting down when in gear

  #1  
Old 06-02-2012
BryanAustin's Avatar
Member
Thread Starter
Join Date: Jun 2012
Location: Simcoe
Posts: 5
Likes: 0
Received 0 Likes on 0 Posts
Speakers shutting down when in gear

Hi, I have recently encountered and issue where the speakers in my 2008 Ford Ranger FX4 shut down when I put the truck in gear,while in neutral or park they come back on. If anyone has any ideas on what the problem could be the help would be appreciated, I have already contacted Ford and they were lost. Thanks.
 
  #2  
Old 06-02-2012
Join Date: Feb 2011
Location: .
Posts: 1,018
Likes: 0
Received 2 Likes on 2 Posts
the radio is on, and when you slide the selector in drive the sound from the speakers just quits?
Dont mean to sound stupid by spelling it out like that but thats really strange
 
  #3  
Old 06-02-2012
BryanAustin's Avatar
Member
Thread Starter
Join Date: Jun 2012
Location: Simcoe
Posts: 5
Likes: 0
Received 0 Likes on 0 Posts
Yes, in park and neutral everything works fine but once its in gear all power to the speakers shuts down, it has me running in circles right now trying to figure it out.
 
  #4  
Old 06-02-2012
06RangerXLT's Avatar
Member
iTrader: (2)
Join Date: Feb 2011
Location: Halton Hills, Ont
Posts: 1,685
Likes: 0
Received 5 Likes on 5 Posts
yea its a common issue but i have yet to find a solution. i had the same problem. there is a wire that goes to the radio, and in certain circumstances, the voltage spikes and causes the radio to cut out.

Pink wire with tiny black stripe. cut this wire and your issue will go away (if it doesn't you can soldier it back together, so cut it mid length). I did it and have had no ill effects from it.

The wire doesn't show up on any wiring schematic, or shop manual. so i have no idea what it does.

also, check if it only does it with your high beams on. i could drive with my high beams on and it would work, but in drive on low beam no dice.
 
  #5  
Old 06-02-2012
BryanAustin's Avatar
Member
Thread Starter
Join Date: Jun 2012
Location: Simcoe
Posts: 5
Likes: 0
Received 0 Likes on 0 Posts
Got no pink wires with black or vice versa, also high beams or low beams doesn't make a difference, do you recall where the wire ran exactly?
 
  #6  
Old 06-02-2012
Rev's Avatar
Rev
Rev is offline
Member
Join Date: May 2005
Location: San Diego, CA
Posts: 1,179
Likes: 0
Received 7 Likes on 6 Posts
Which sound system option do you have (base, Audiophile, or satellite) and does the radio display still show it’s powered up when the speakers cut out or does the display cut out as well?
 
  #7  
Old 06-02-2012
06RangerXLT's Avatar
Member
iTrader: (2)
Join Date: Feb 2011
Location: Halton Hills, Ont
Posts: 1,685
Likes: 0
Received 5 Likes on 5 Posts
Originally Posted by BryanAustin
Got no pink wires with black or vice versa, also high beams or low beams doesn't make a difference, do you recall where the wire ran exactly?
i never bothered to follow it

Originally Posted by Rev
Which sound system option do you have (base, Audiophile, or satellite) and does the radio display still show it’s powered up when the speakers cut out or does the display cut out as well?
good question^




only thing id suggest is get back there with the radio on and cycle through N and D while check each wire going to the back of the radio. wait for the one that changes voltage
 
  #8  
Old 06-02-2012
BryanAustin's Avatar
Member
Thread Starter
Join Date: Jun 2012
Location: Simcoe
Posts: 5
Likes: 0
Received 0 Likes on 0 Posts
Using the stock ranger stereo, it has satellite radio hooked up and yes the display still shows everything as running when the speakers cut out.
 
  #9  
Old 06-02-2012
Toreador4x4's Avatar
Member
iTrader: (6)
Join Date: Apr 2007
Location: Livonia, MI
Posts: 3,958
Likes: 0
Received 3 Likes on 3 Posts
Ive seen this caused by the transmission range sensor many times. start the engine, disconnect the range sensor, and put it in drive and see if the radio remains on
 
  #10  
Old 06-02-2012
BryanAustin's Avatar
Member
Thread Starter
Join Date: Jun 2012
Location: Simcoe
Posts: 5
Likes: 0
Received 0 Likes on 0 Posts
OK i unplugged the range sensor and the first time i unplugged it, it took about 10sec and then all the speakers shut down again this time even while in park or neutral, I shut the truck down and tried again and had no delay in the shut down just immediately all sound shut off.
 
  #11  
Old 06-02-2012
Rev's Avatar
Rev
Rev is offline
Member
Join Date: May 2005
Location: San Diego, CA
Posts: 1,179
Likes: 0
Received 7 Likes on 6 Posts
Bryan, unfortunately I'm not familiar with these new fangled Sat systems. It's making reference to computer data lines, not sure what they go to.. If you want to PM me your email, I can send you the wiring diagrams.
 
  #12  
Old 09-29-2015
hytechredneck's Avatar
Member
Join Date: Sep 2015
Location: rougemont,n.c.
Posts: 1
Likes: 0
Received 0 Likes on 0 Posts
Icon12

i own a shop and we have your speaker problem in our service bay, we have found the problem ! go to the fuse box on the right kick panel ,you will be looking for water. remove a pillar trim and kick panel . disconnect the battery,remove what ford calls the smart junction box, make sure all moisture is removed. we took the fuse box out and dried with shop air ,a fan under the dash over knight) plug everything back in ,connect battery and all is as it should be. the water on ours was leaking into the truck through the upper right corner of the windshield .with all the trim out of the way i sat inside my son flooded that side with a garden hose to locate leak
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Shaklakan
Audio & Video Tech
3
07-25-2008 09:45 AM
jtfoxman
4.0L OHV & SOHC V6 Tech
2
12-13-2007 07:54 AM
doug435
Audio & Video Tech
5
01-30-2006 12:50 PM


Thread Tools
Search this Thread
Quick Reply: Speakers shutting down when in gear



All times are GMT -6. The time now is 07:34 AM.