What is all needed to get it to work? i have a factory 6disc mp3 unit out of an 04 ranger in my 01 now..if/when i find the console how would it hook-up?

first i got to find the console...


ANYONE GOT ONE FORSALE????

 

anyone?

 

console is the main thing.....then you have to have the AUX plug to go into the back of the radio.........

the consoles are pretty hard to find in a wrecked truck......since they haven't been that big of a hit in new trucks......

 

i dont remember if the radio i got has the aux or not...if it dont is there still a way to get it to work?

 

i am sorry, i told you wrong.....you don't need the AUX button.....

you do however have to tap into 2 + speaker wires and 2 - speaker wires.....and then have a + supply and a ground.....

i have a wiring diagram for it at home on my desktop.....but i am on my laptop now....

 

You can buy the plug for the radio side. As for running it without it yes I am right now off of my after market headunit and a amp. When I switch back to a factory radio I am going to run a Audiocontrol LC6 and run that to my amps.

 

I was able to swap my entire system for the Pioneer setup...I just reconnected everything and it works like a charm now.

 

this is the radio i got

 

I don't think you can tell from the front. How many plugs were there on the back of the radio.

Edit: that doesn't look like the one I have, you need the one that says Pioneer on the front.

 

just the main harness

 

yeah from the sounds of it that is just a normal 6 disk/mp3. If it was the one from the factory subwoofer system it would of had to plugs on the back of the radio. But you can still run the subwoofer off of a aftermarket amp. If you are still wanting to run it look into one of these and just run everything off of aftermarket amps.
http://www.sonicelectronix.com/item_...GRAY+LC6-.html

or if you need a aux input.
http://cgi.ebay.com/AudioControl-LC7...QQcmdZViewItem