New scanguage II, troubles.
#1
New scanguage II, troubles.
Just bought a Scanguage II.
My primary reason for wanting it is the trans temp feature. I have it programmed in, but it won't read anything. Just a blank TFT on the gauge screen.
Also, I noticed it doesn't seem to switch from closed loop to open loop at operating temperature. Maybe I didn't get the vehicle hot enough, it's only about 23F outside.
Ideas/help?
My primary reason for wanting it is the trans temp feature. I have it programmed in, but it won't read anything. Just a blank TFT on the gauge screen.
Also, I noticed it doesn't seem to switch from closed loop to open loop at operating temperature. Maybe I didn't get the vehicle hot enough, it's only about 23F outside.
Ideas/help?
#3
It starts out in open loop, then changes to closed loop well before the coolant is fully warmed up.
Closed loop means it is adjusting the A/F ratio using feedback from the O2 sensor.
Last edited by woo; 12-11-2011 at 03:26 PM.
#4
#5
Actually there are 4 versions. The first one worked for me.
Transmission Fluid Temperature
07E0221674
046205160674
3010
000100080000
TFT
Degrees Fahrenheit
07E0221674
046205160674
3010
000100080000
TFT
Degrees Fahrenheit
#6
#7
#9
In another forum that I belong to there is a long thread that he started just to answer questions. Perhaps he would visit this forum?
#10
Well, after some fiddling, it works. The only thing I changed was the trans temp location on the readout, and it now works.
It read blank TFT in the top left corner, but I discovered it works in the lower right corner, even when the top left is still displaying nothing. Curious, but it works.
Thanks for the support.
It read blank TFT in the top left corner, but I discovered it works in the lower right corner, even when the top left is still displaying nothing. Curious, but it works.
Thanks for the support.
Thread
Thread Starter
Forum
Replies
Last Post
outdoorsman
Ranger Products, Company, & Member Reviews
0
08-13-2008 06:11 PM