no start
#2
RF Veteran
iTrader: (1)
Welcome to the forum
?? "checked on computer,said pcm was bad" ??
There is no way to test a computer and they rarely fail, not never, rarely
50/50 test
Spray gasoline or Starting Fluid(ether) into the intake
Try to start engine
If it starts then you have spark but are out of gas or fuel injection system is not working
If it doesn't start then there is no spark, or no compression
50/50
First look if the timing belt is turning when you try to start, 2.3l can break timing belt and then no compression so no start.
The ICM(ignition control module) runs the spark on a '93 2.3l
It is located on the front of the intake, most auto parts stores can test these, and they were a common failure
Drawing here: http://repairguide.autozone.com/znet...3f8021b7f1.gif
PCM(computer) is in engine bay drivers side behind wheel well against firewall
Drawing here: http://www.justanswer.com/uploads/fo...pcm_ranger.jpg
Info about 1994 and earlier PCMs here: Ford EEC-IV
Also called EEC-IV, the 1995 and up are EEC-V
?? "checked on computer,said pcm was bad" ??
There is no way to test a computer and they rarely fail, not never, rarely
50/50 test
Spray gasoline or Starting Fluid(ether) into the intake
Try to start engine
If it starts then you have spark but are out of gas or fuel injection system is not working
If it doesn't start then there is no spark, or no compression
50/50
First look if the timing belt is turning when you try to start, 2.3l can break timing belt and then no compression so no start.
The ICM(ignition control module) runs the spark on a '93 2.3l
It is located on the front of the intake, most auto parts stores can test these, and they were a common failure
Drawing here: http://repairguide.autozone.com/znet...3f8021b7f1.gif
PCM(computer) is in engine bay drivers side behind wheel well against firewall
Drawing here: http://www.justanswer.com/uploads/fo...pcm_ranger.jpg
Info about 1994 and earlier PCMs here: Ford EEC-IV
Also called EEC-IV, the 1995 and up are EEC-V
Last edited by RonD; 12-11-2016 at 12:17 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Pilot
General Technical & Electrical
3
10-27-2013 07:07 AM
Jerkstore
General Technical & Electrical
4
10-02-2011 09:53 AM