Need Seatbelt Pretensioner wiring help!!!!
#1
Need Seatbelt Pretensioner wiring help!!!!
So picked up a 2001 Ranger XLT supercab and the airbag light is on. It blinked code 4-6. Checked the driverside pretensioner and noticed that the wires were cut right after they clipped together. The two wires are a black wire and a gry/blue wire.
Now, I'm assuming that I can just splice the wires back to where they belong and my issue will be solved. However, I cannnot find where they were cut from. I did notice however that in the wiring harness under the seat the same color wires seem to be cut and poking out but they seem thinner than the cut wires.
Is this where I need to splice the wires from the seatbelt in or is there a different spot where the pretensioner wires poke out and with regards to the harness I have a seperate issue.
Pics of the location of the wires would be helpful. Thanks!
-Tom
Now, I'm assuming that I can just splice the wires back to where they belong and my issue will be solved. However, I cannnot find where they were cut from. I did notice however that in the wiring harness under the seat the same color wires seem to be cut and poking out but they seem thinner than the cut wires.
Is this where I need to splice the wires from the seatbelt in or is there a different spot where the pretensioner wires poke out and with regards to the harness I have a seperate issue.
Pics of the location of the wires would be helpful. Thanks!
-Tom
#2
Thread
Thread Starter
Forum
Replies
Last Post
winks
General Technical & Electrical
2
07-10-2008 06:31 AM
winks
General Technical & Electrical
9
05-13-2008 01:27 PM
rngprerunner
General Technical & Electrical
20
02-20-2006 09:01 PM