1990 ranger starting problem
#1
1990 ranger starting problem
I need help with my truck, it wont start or even turn over.
About a mounth ago I had to jump it to get it to start, that same day it over heated and wont start since.
I've replaced the battery, both positive cables, negative cable, Solenoid
When I put the battery in all the lights where bright inside, then when I went to start it the solind made a tick sound and the lights turned off. when I dicontect the cables and try agian it does the same thing.
Does anyone know what this problem could be.
Thanks - Benjamix
About a mounth ago I had to jump it to get it to start, that same day it over heated and wont start since.
I've replaced the battery, both positive cables, negative cable, Solenoid
When I put the battery in all the lights where bright inside, then when I went to start it the solind made a tick sound and the lights turned off. when I dicontect the cables and try agian it does the same thing.
Does anyone know what this problem could be.
Thanks - Benjamix
#4
the part with the lights going out after the solenoid clicks confuses me. but if the starter wont physically turn to start the engine, that sounds like a bad ground through the starter. to fix that you would need to remove the starter and break down the 3 sections of it and sand each end and replace.
Thread
Thread Starter
Forum
Replies
Last Post
smokindmax
SOHC - 2.3L & 2.5L Lima Engines
5
09-01-2009 10:33 AM