General Technical & Electrical General technical and electrical discussion for the Ford Ranger that does not fit in any other sub-forum.

Computer messing up?

Thread Tools
 
Search this Thread
 
  #1  
Old 06-10-2010
LancerRevo's Avatar
Member
Thread Starter
Join Date: Jun 2009
Location: El Paso, TX
Posts: 262
Likes: 0
Received 0 Likes on 0 Posts
Computer messing up?

Ok so i was leaving work, and i noticed my ABS light came on. So i was like ok.... maybe brake fluid is low, so i check and it was at the max line. So i started driving and then i noticed it was taking forever to shift, and then it did really really hard. Then i noticed the speedometer and odometer weren't moving....ok. So i called my brother, came by and unplugged the battery for a bit, same thing. So i started driving it home, and come around 45 or so the speedometer works(didn't notice if the miles were, too worried to care) so i drove and asked my brother and we were going to same speed..... Brother says it may be the speed sensors going out.

so what can all this be?

Im thinking a couple things maybe, just to throw out there that could have caused this:

Bigger tires, never programmed so speedometer is 5 miles off.

Had to change out my driver sides axel shaft in the rear(caused my brakes to go out and all)

Too late to run to autozone and plug in, so i have to wait till tomorrow morning now :/.
 
  #2  
Old 06-10-2010
demiseranger's Avatar
Member
iTrader: (2)
Join Date: May 2008
Location: Tucson , Arizona
Posts: 331
Likes: 0
Received 0 Likes on 0 Posts
Get a new ABS/Speed Sensor. It plugs into the top of the axle. Larger tires wouldn't affect the sensor.
 
  #3  
Old 06-10-2010
LancerRevo's Avatar
Member
Thread Starter
Join Date: Jun 2009
Location: El Paso, TX
Posts: 262
Likes: 0
Received 0 Likes on 0 Posts
Well im planning on changing both, 15 bucks each at autozone. One goes on the differential and other goes on transmission. Hopefully the abs sensor isnt bad, thats 60 bucks for one
 
  #4  
Old 06-10-2010
demiseranger's Avatar
Member
iTrader: (2)
Join Date: May 2008
Location: Tucson , Arizona
Posts: 331
Likes: 0
Received 0 Likes on 0 Posts
You only have one VSS sensor on the axle housing. The VSS located on the transmission is for 93-97 and 01-on. The 98-00 VSS sensor is also the ABS sensor.
 
  #5  
Old 06-10-2010
LancerRevo's Avatar
Member
Thread Starter
Join Date: Jun 2009
Location: El Paso, TX
Posts: 262
Likes: 0
Received 0 Likes on 0 Posts
Well i changed the rear sensor, and my abs light went off but my check engine light is on still. resetted the computer and still on :/. I cant find the other sensor on the tranny either, so we just gave up and went back to bed haha. damn i have work today so i cant check it at autozone again. Speedometer and all works again, shifts fine again. I just dont know whats throwing it off now
 
  #6  
Old 06-10-2010
demiseranger's Avatar
Member
iTrader: (2)
Join Date: May 2008
Location: Tucson , Arizona
Posts: 331
Likes: 0
Received 0 Likes on 0 Posts
You do not have a sensor on the transmission. The CEL may be due to the transmission shifting hard, it happened to me when I swapped in my new axle and didn't have a speedo.

Did you disconnect the battery and turn on the headlights?
Glad you have your speedo working again
 
  #7  
Old 06-11-2010
LancerRevo's Avatar
Member
Thread Starter
Join Date: Jun 2009
Location: El Paso, TX
Posts: 262
Likes: 0
Received 0 Likes on 0 Posts
Wow that worked haha. Thanks a bunch!!
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Trigger01
Ranger-Forums Office
11
03-04-2009 06:42 PM
The S-10 Killer
Snapshots
2
01-10-2009 12:23 PM
RockysFord
Drivetrain Tech
16
03-20-2006 07:49 PM
fletch12518
General Technical & Electrical
21
01-23-2006 11:59 AM



Quick Reply: Computer messing up?



All times are GMT -6. The time now is 04:50 AM.