How to pull ignition cylinder?
#1
How to pull ignition cylinder?
All I have a 1992 Ranger with a standard non tilt column and need to remove the ignition cylinder. I have most of the column torn down but Ijust don't see how the cylinder is retained in the coulmn. The Haynes I have is for 1993 and newer and the columns must of changed becuase it isn't much help
#2
#4
Good luck! It's a nightmare!
I've been told that you can drill out the pin that holds it in, but if you try that be careful. I had to swap out my column about 5 months ago because the bearings went bad and was lucky enough to find a donor at the local pick-n-pull with the keys. Then I just swaped my old cylinder into it.
Allen
I've been told that you can drill out the pin that holds it in, but if you try that be careful. I had to swap out my column about 5 months ago because the bearings went bad and was lucky enough to find a donor at the local pick-n-pull with the keys. Then I just swaped my old cylinder into it.
Allen
#5
Thread
Thread Starter
Forum
Replies
Last Post
redneckjust
General Technical & Electrical
8
09-03-2010 01:15 PM
The S-10 Killer
General Technical & Electrical
4
06-27-2009 12:20 PM