General Technical & Electrical General technical and electrical discussion for the Ford Ranger that does not fit in any other sub-forum.

<<HELP.. Truck Wont Turn Over ..HELP>>

Thread Tools
 
Search this Thread
 
  #1  
Old 06-12-2009
johnson's Avatar
Member
Thread Starter
iTrader: (-1)
Join Date: Nov 2005
Location: Las Vegas, NEVADA
Posts: 281
Likes: 0
Received 0 Likes on 0 Posts
<<HELP.. Truck Wont Turn Over ..HELP>>

the truck is a 2003 4 bangwer 5 speed.....


i just bought the ranger up in tahoe from the guy that rolled it and did the cab swap..... it wont turnover from the key.... it has power to the guages and blinkers and all but wont turn over from the key.... i can jump it off the starter and it will turn over.... the neutral saftey switch is not under the dash, its in reach so i push that in so the ecu thinks the clutch is depressed, and still nothning...

any ideas.... im about to put a push button start in it if i cannot figure it out... but i know it is something simple....

help guys....

thanks
 
  #2  
Old 06-12-2009
DaisyDuke's Avatar
Member
Join Date: May 2009
Location: greenville sc
Posts: 128
Likes: 0
Received 0 Likes on 0 Posts
if you need it to run right this second pushed it to roll it to a start then pop it into first gear its a ford they have plenty of electical problems but id have to be there to tell you whats wrong good luck!
 
  #3  
Old 06-12-2009
johnson's Avatar
Member
Thread Starter
iTrader: (-1)
Join Date: Nov 2005
Location: Las Vegas, NEVADA
Posts: 281
Likes: 0
Received 0 Likes on 0 Posts
damn.... well i want to fix it not just push start.. haha well thanks...
 
  #4  
Old 06-12-2009
cchsbuzz19's Avatar
Member
iTrader: (5)
Join Date: Jul 2007
Location: North Canton, Ohio
Posts: 2,417
Likes: 0
Received 2 Likes on 2 Posts
If your not getting anything from the key, Your starter could have went bad.
 
  #5  
Old 06-12-2009
johnson's Avatar
Member
Thread Starter
iTrader: (-1)
Join Date: Nov 2005
Location: Las Vegas, NEVADA
Posts: 281
Likes: 0
Received 0 Likes on 0 Posts
ok... im gunna pull the starter and bunch test it and have checker test it,....
 
  #6  
Old 06-12-2009
FullThrottle02's Avatar
Member
iTrader: (3)
Join Date: Apr 2008
Location: McHenry,IL
Posts: 586
Likes: 0
Received 0 Likes on 0 Posts
Does that have PATS? It may be preventing it from starting IDK. Could be ignition switch related.
 
  #7  
Old 06-12-2009
Rev's Avatar
Rev
Rev is offline
Member
Join Date: May 2005
Location: San Diego, CA
Posts: 1,179
Likes: 0
Received 7 Likes on 6 Posts
I believe there is a starter relay located in the BJB. The power flows from the clutch switch to the relay's coil. The coils ground is controlled by the PCM. If this relay is not functioning properly the starter will not work.
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
chop1381
Drivetrain Tech
4
06-17-2019 09:31 PM
PDXracer
SOHC - 2.3L & 2.5L Lima Engines
3
10-06-2014 07:41 PM
97RANGE23
SOHC - 2.3L & 2.5L Lima Engines
21
05-07-2012 05:24 PM
ghostindadark
2.9L & 3.0L V6 Tech
0
06-28-2009 01:31 PM
Off-roadranger04
4.0L OHV & SOHC V6 Tech
5
05-31-2009 08:15 PM



Quick Reply: <<HELP.. Truck Wont Turn Over ..HELP>>



All times are GMT -6. The time now is 11:58 PM.