General Technical & Electrical General technical and electrical discussion for the Ford Ranger that does not fit in any other sub-forum.

dash electronics dead...poppin fuses

  #1  
Old 05-15-2005
Alon's Avatar
Member
Thread Starter
iTrader: (13)
Join Date: Jun 2004
Location: Long Beach, CA
Posts: 2,555
Likes: 0
Received 3 Likes on 1 Post
dash electronics dead...poppin fuses

well i installed the ohc today and everything was working great, drove around and it was perfect. wne out later tonight and the dash was dead, no tach, speedo, odometer, no lights...... all dead.

the ohc lights up and works fine, radio works fine, ac lights dont work, fog light switch is dark too.

fuse 33 keeps popping and i dont knwo what to do. we didnt go anywhere near the wiring for the dash so i dont know what the problem is

please help!
 
  #3  
Old 05-15-2005
n3elz's Avatar
RF Veteran
Join Date: Jun 2004
Location: Kennett Square, PA
Posts: 10,623
Likes: 0
Received 4 Likes on 4 Posts
Yes. I've used it for a couple of things. No problems.

Which fuse 33 are we talking about? In the engine compartment or in the cab? You shouldn't have one in the cab unless you have daytime running lights.

Fuse 33 in the engine compartment goes to just two places: the light switch and the CSM (keyless entry module). You probably lose keyless entry when this happens also, yes?

On the light switch, it feeds the panel dimmer. That wire you DID tap into at the radio, and perhaps when you routed it up to the console you have a splice that comes apart and shorts, or a wire that is rubbed through the insulation or pinched. I'd check that first.

Also, it makes no sense what you posted: are your dash electronics DEAD, or do they just not light up. Fuse 33 shouldn't be causeing the whole dash to go dead, only the lighting of it.
 
  #4  
Old 05-15-2005
V8 Level II's Avatar
RF Veteran
iTrader: (4)
Join Date: Nov 2004
Location: Michigan
Posts: 7,910
Likes: 0
Received 23 Likes on 20 Posts
Originally Posted by n3elz
Yes. I've used it for a couple of things. No problems.

Which fuse 33 are we talking about? In the engine compartment or in the cab? You shouldn't have one in the cab unless you have daytime running lights.

Fuse 33 in the engine compartment goes to just two places: the light switch and the CSM (keyless entry module). You probably lose keyless entry when this happens also, yes?

On the light switch, it feeds the panel dimmer. That wire you DID tap into at the radio, and perhaps when you routed it up to the console you have a splice that comes apart and shorts, or a wire that is rubbed through the insulation or pinched. I'd check that first.

Also, it makes no sense what you posted: are your dash electronics DEAD, or do they just not light up. Fuse 33 shouldn't be causeing the whole dash to go dead, only the lighting of it.
The 2004s have the new electronic cluster powered from 33 in the so-called Smart Junction Box in the PS kick panel. It is constant B+ for the cluster but not the nighttime illumination. The LB/RD IP illumination current passes through fuse 31 and then fuse 1, both also in the SJB.
 
  #5  
Old 05-15-2005
n3elz's Avatar
RF Veteran
Join Date: Jun 2004
Location: Kennett Square, PA
Posts: 10,623
Likes: 0
Received 4 Likes on 4 Posts
Good to know. He has a 2001 though.

Did you get 2003/2004 service manuals on CD somewhere, Bob? I haven't found them. Or do you have paper? I seem to remember you saying somewhere you had the books.
 
  #6  
Old 05-15-2005
gatorblue92's Avatar
RF Veteran
Join Date: Jun 2004
Location: Delaware
Posts: 8,238
Likes: 0
Received 2 Likes on 2 Posts
i had a similar problem when i installed my cd changer... i had a bad splice that shorted out and blew my fuses.... as for borrowing power from the radio i have the radio (duh) ohc and cd changer all going on the same circuit with no problems
 
  #7  
Old 05-15-2005
Join Date: Jun 2004
Location: Exit 105 New Jersey
Posts: 2,409
Likes: 0
Received 0 Likes on 0 Posts
is it your truck or Bailey's that is having the problems Alon?
Bailey posted in GE and the thread appears to be cut & paste job so it's a real puzzle
 
  #8  
Old 05-15-2005
Alon's Avatar
Member
Thread Starter
iTrader: (13)
Join Date: Jun 2004
Location: Long Beach, CA
Posts: 2,555
Likes: 0
Received 3 Likes on 1 Post
mine.
 
  #9  
Old 05-15-2005
n3elz's Avatar
RF Veteran
Join Date: Jun 2004
Location: Kennett Square, PA
Posts: 10,623
Likes: 0
Received 4 Likes on 4 Posts
Then my original post applies. Most likely you have a short in the wire you tapped into the blue/red wire on the radio.
 
  #10  
Old 05-15-2005
Alon's Avatar
Member
Thread Starter
iTrader: (13)
Join Date: Jun 2004
Location: Long Beach, CA
Posts: 2,555
Likes: 0
Received 3 Likes on 1 Post
there was a short in the blue/red wire to the radio. i driled a hole to keep the wires more organized and better routed but forgot to tape the wires so they wont get cut on the edges of the hole.
 
  #11  
Old 05-15-2005
n3elz's Avatar
RF Veteran
Join Date: Jun 2004
Location: Kennett Square, PA
Posts: 10,623
Likes: 0
Received 4 Likes on 4 Posts
Very good! Well, it's a detail you can't ignore in a vehicle since wires get shaken around so much. Lesson learned type of thing. I've had plenty of those.
 
  #12  
Old 05-15-2005
V8 Level II's Avatar
RF Veteran
iTrader: (4)
Join Date: Nov 2004
Location: Michigan
Posts: 7,910
Likes: 0
Received 23 Likes on 20 Posts
Originally Posted by n3elz
Good to know. He has a 2001 though.
Ha ha! I got confused. Bailey posted Alon's symptoms on G-E under her screen name with her signature (2004). I thought these problems were on her truck.

Originally Posted by n3elz
Did you get 2003/2004 service manuals on CD somewhere, Bob? I haven't found them. Or do you have paper? I seem to remember you saying somewhere you had the books.
Yes, I have all of my Wiring Manuals on paper. The only thing I have on CD is a 2002 shop manual.
 

Last edited by V8 Level II; 05-16-2005 at 06:34 AM.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
CrazyAznEdge
Audio & Video Tech
9
04-24-2020 09:51 AM
computerflake
General Technical & Electrical
9
09-07-2013 10:59 AM
04RangerDave
Suspension Tech
14
11-18-2011 11:50 AM
b3kbruiser
General Technical & Electrical
3
11-30-2006 02:01 PM
INT3RC3PTOR
Interior Semi-Tech
20
04-09-2006 06:26 AM


Thread Tools
Search this Thread
Quick Reply: dash electronics dead...poppin fuses



All times are GMT -6. The time now is 11:40 PM.