bad battery/ altenator???
#1
bad battery/ altenator???
Ok so for a little while now I have noticed that the dummy light for the battery has been coming on, also noticed that the actual gauge for the battery is riding lower than it should. Has been starting normally even as cold as its been at night. So today I stop in at Auto Zone on the way home from work and have both tested. The battery has a small amount of crud on the post but checks out good and then start her up and she is running 14.2 on the tester. So he tells me it's not the altenator but could be a bad cell in the battery. I decide to try cleaning the post once I get home and see what happens. On the way which is about 12 miles the light stays on the entire time and then the ABS light comes on,then the seat belt light comes on, then the radio quits, the tach stops working and the speedo is doing who knows what. I have the window down and try to put it up and the truck jerks and I know better than to try it again. As I pull up the drive it tries to die and I gimp it on up and park it. Tried to roll the window up and she does indeed die. I have done nothing to it yet. WTF is the problem????
#11
#13
Old Guy User…
iTrader: (12)
Grounds are the most important part of the electrical system so as stated above check, clean and tighten all of the ground points.
Then check the battery/alt again and see what happens.
When Auto Zone checks an Alternator or battery, they do a load test which puts a strain on the system. This is turn will (sometimes) excite an alternator or battery enough to get a good reading for a little while then things will crap up again !
When checking the grounds, start at the battery cables, then the battery ground point, then the frame/block points, also with a multimeter check to see if the alternator case is grounded back to the battery grounding on the fender.
Also, if/when you replace the alternator consider doing the battery too, unless it has been replace earlier and don’t forget new cabling from the alternator to the battery and as much of the ground wire as possible and go one size larger if you can.
Sounds like a lot but putting in a new alternator/battery is nice and will work ok for a wile but if the current can’t flow then the system will not work well for long.
Luck
Then check the battery/alt again and see what happens.
When Auto Zone checks an Alternator or battery, they do a load test which puts a strain on the system. This is turn will (sometimes) excite an alternator or battery enough to get a good reading for a little while then things will crap up again !
When checking the grounds, start at the battery cables, then the battery ground point, then the frame/block points, also with a multimeter check to see if the alternator case is grounded back to the battery grounding on the fender.
Also, if/when you replace the alternator consider doing the battery too, unless it has been replace earlier and don’t forget new cabling from the alternator to the battery and as much of the ground wire as possible and go one size larger if you can.
Sounds like a lot but putting in a new alternator/battery is nice and will work ok for a wile but if the current can’t flow then the system will not work well for long.
Luck
#14
This exact thing just happened to me(to a T) The advance auto parts guy said my napa battery(came with the truck) had a bad cell and that in turn killed my alt. bench testing the alt showed 10 volts. i replaced the alt 95 amp and the battery(better one not a cheapie) All is good for now but i will check those grounds for peace of mind.
Thread
Thread Starter
Forum
Replies
Last Post
waterfowler07
General Technical & Electrical
3
08-31-2008 09:45 PM