The drivers side seat with out the seat rails attached.
Drivers side seat scuff. Looks much worse in this picture.
From Left to Right: Pass side seat with rails installed, FL CC, Drivers side without rails installed.
FL CC Cupholders and Cubby Hole
Both Seats are power and have manual lumbar support
FL CC Rear Fold Down Cupholders
I Remind anyone that is interested in these seats that 1. The motors are no good and new seat tracks would need to be acquired since new motors for these seats are not available. 2. The drivers seat power plug had been cut for quick connects but since you probably wont be using these seat tracks it isnt an issue anyway. I dont have the rear heat controls for the FL CC as I knew I didnt need it anyway. There is also no lid for the CC as when I took it out of the explorer. The seats and the CC are out of the same explorer so they are all colored and look the same. The seats are still firm lumbar still works on both and as far as I know once new power seat tracks are bolted to them everything else will work as well. These are very nice seats and the only reason I did not invest time to get them into the ranger is because I upgraded to a 3/4 ton.