Heres a couple pics
I just pasted pics of the actuator and rod in their approximate locations within the door. I had to bend the end to line up with the bent stock rod to clamp them together.
This is at the bottom of the door where the actuator is mounted. The top screw has a nut used as a spacer between the actuator and the sheet metal. This angles the actuator arm away from the wire harness that is there.
And this is the view through the little square hole at the top of the first pic. This is where the rods are clamped together and you have access to tighten the clamp.
And dont forget the Loctite!