Power Windows & Locks Kit
#1
Power Windows & Locks Kit
Does anyone know of a good aftermarket power windows and locks kit for a 2000 Ranger? I would rather go factory, but my truck is not wired for it so I figure aftermarket would probably be the best bet. If anyone can point me in the right directions I would appreciate it very much.
#5
Does anyone know anything about this door lock kit. I found it on ebay......
http://cgi.ebay.com/ebaymotors/FORD-...spagenameZWD1V
http://cgi.ebay.com/ebaymotors/FORD-...spagenameZWD1V
#9
#13
#14
Originally Posted by melj2000
How much did that power lock kit set you back and what is included with it?
2 door power locks and keyless entry
The one I bought upgrades the keyless entry system to a Directed Electronics keyless entry system, who makes Clifford and Viper alarm systems, for $10 more:
2 door power locks w/ 712T keyless entry
The A-1 kit includes everything you need, except maybe a few washers or nuts to space out the power lock actuators from the door. Other than that you are good to go. It's not too difficult to install, it just takes a little time to tear everything to peices (door panels, the dash panel under the steering wheel), mount the actuators, bend the rods precisely to line up w/ the lock rods, time the actuators, run the wires through the boots to the doors, tie everything up out of the way, mount the relays, get it all back together, etc. Where you have to mount the actuator rods in the door on the Rangers, it's pretty difficult to get in there to time (center) them w/ the locks, and tighten the keepers. Kind of working blind. Other than that, it's pretty straightforward, just time consuming.
The keyless entry fob on the latter system I purchased is not much bigger than the black part on your Ranger key. pretty nice stuff:
Thread
Thread Starter
Forum
Replies
Last Post
TommyC
General Ford Ranger Discussion
7
09-09-2015 12:34 AM
Jonesy2081
Interior Semi-Tech
17
04-26-2005 07:15 PM