ok well i have a standard cab truck and i have been thinking this is my plan... work with me here....... ok i am going to cut a hole from the bed to the cab of the truck and put a piece of the flexiable plastic between there. in the bed i will build a box to hold my subs bolt it down and cover it with the bed liner stuff... then cut out the bottom of my tool box so when it rests on the box you cant see it and the top of the sub box is like the bottom of the sub box...... lol good idea?

 

No. Bad idea. Just put some sub boxes behind your seats. You truck flexes to much to cut a hole in it and put plastic there.

 

they wont fit inside already tried it would be that acordian (sp) stuff lol the stuff that flexes all over... my friends got it on his bagged s10

 

There are quite a few people who have managed to fit subs behind the seats. If you want to do something custom, you could do the seat mod and build a custom console to hold you amp & sub(s).

 

true true.... idk i could only fit 2 10's if i did that... if i make my own thing there will be 4 kicker cvr's lol

 

I have seen this done before.

 

damnit lol well is it good or bad?

 

If you dont offroad I would say do it but I dont know how well it would hold up offroad

 

Ive seen plenty of single cabs with subs behind the seats. And what about gettin one nice sounding 10" throw it behind the passenger seat so u dont sacrafice any of your seat room...

Rockford Fosgate is an amazing sound... and two of em together ... heavenly! haha I would say the idea is a lot of work when there are good alternatives...

Just what Im thinkin... but hey its your truck and if that makes you happy go for it... post pics

 

i had them behind the seat i am too tall my knees end up to my chest

 

Well there in lies the problem... have you considered goin by a custom fab place and seein what they say... and thennnnn... using their ideas?

 

i worked at a sterio shop for a year and a half... and i work at a body shop now..

 

Well dammmmmnnn.... i dont know then. under the seats? no not enough room...I suppose the idea you had would work ... it seems like the only way

 

lol i may try it... lol i will take ALOT of pictures if i do try it

 

Get an extended cab.

 

I think it would vibrate way too much and possibly distort the sound..

though I like my bazooka tube!

 

i cant afford a new truck lol well see i have seen it before not quite like this though lol

 

I understand. I just don't think the toolbox would be the best idea, I think it would vibrate to much, just as FX2.3 said and it would really take a lot of work to build a good quality box.

 

i have built all my boxes... i am just trying to decide how i would do the tool box thing right lol maybe put like a layer of something between them or something

 

Have you thought about removing the toolbox and custom making a box to go in the bed, something that will set level with or below the bed rails?

 

it will be down low and the box being on top will make it hard to take... like the top of the speaker box will be the bottom of the tool box that close of a fit i would jsut have to put down some type of rubber mat

 

what about a locking Tonneau? then you could throw the box in the bed like was said before...??

 

shouldnt this be in the new idea forum, lol.

 

lol most likely

 

its called a blow through easy as **** to make, and function well if done right