ohc installed!!
#1
ohc installed!!
Ok so i was a little scared about doing this but after i got into it, it wasn't bad at all. Damage control is a two count but oh well. One a pillar is cracked but not noticable so when i have time ill replace it. Two was the dome light is trashed because it didnt want to come out. So i forced it out by accident and know have a mustang dome light on the way to add to the interior :) 90 percent done. Only thing i need to do is wire in the temp sensor and thats it! Only question i do have is this, if i dont feel the temp sensor will hold in place by the push pin thingy what can i do to keep it in place?
And know the pics
ohc install 2 picture by alaw03 - Photobucket
stock ride hight picture by alaw03 - Photobucket
And know the pics
ohc install 2 picture by alaw03 - Photobucket
stock ride hight picture by alaw03 - Photobucket
#8
I kinda like it i also like the blue im getting one next week orderd it today, the guys shipping it tomorrow. Hes gonna sand it and get it ready for me to prime and paint. Imma paint mine same color. Is there any tips u got for me for instaling this. iv never messed with wires before so im very nervous about installing this.
#11
dcrymess99ranger just look on all the fourms and read the write ups there all good and tell u everything you need to do. I found here and therangerstation.com has great write ups about it. Thanks for all the coments. Any tips for painting that blue well first dont paint in cold weather lol. I might have to redo mine due to cold weather painting. I did a few coats of primer and then a few coats of high temp ford blue engine paint.
Thread
Thread Starter
Forum
Replies
Last Post