Help ASAP!!!!!
#1
Help ASAP!!!!!
I did the little mod where you use transparent paint to change the colors on your gauges. That's all done and I'm re-installing everything. I got it all hooked up to make sure everything works and my tach isnt. It appears that everything else is working fine, but when I start it, my RPMs dont change nor when I rev. the motor. Someone please HELP!!!!
#6
#7
The tach signal should be the tan/yellow wire on the 16-pin connector that goes to the cluster. Might want to check the cluster side of that connector for damage...and the rest of that flimsy excuse for a circuit board as well. My vote is the needle, though. I had the speedo needle off when swapping the speedo/odo guts and its a pain to get it back on right.
#8
Thread
Thread Starter
Forum
Replies
Last Post
rybread5520
General Technical & Electrical
2
01-02-2009 09:41 PM
TippnOver
Interior Semi-Tech
7
02-02-2005 11:56 AM