what did I do wrong? or did I?
#1
does anybody know where to find the zones for the OHC?
i just finished putting in my OHC. we went for a drive and i noticed the compass is way out of whack and it takes forever to change direction. Did i miss something or is there something wrong. i followed the write up to a T. Im lost....literally.
Last edited by Ushkie; 05-17-2007 at 09:27 PM. Reason: need more info?
#4
Fourth Step
Well you are done (lets hope). Put the key in the ignition and turn it and see if the console powers on and reads the temp properly (it will read 0 degrees if it isn't hooked up correctly).
Go find an abandoned parking lot and follow the following steps:
Press and hold the "MODE" button until you see "VAR" (takes around 5 seconds)
Release the "MODE" button. Push the "MODE" button until you have selected the zone you are currently in. (email me to find out your zone, I'll soon have a map up)
Release the "MODE" button and wait until the console is back at normal operation.
Press and hold the "MODE" button until you see "CAL" (takes around 9 seconds)
Release the "MODE" button.
Now the fun part. People will think you are crazy. Drive in a circle at around 3mph. Your console will be changing direction really fast. Continue to do this until the console is back at normal operations.
http://www.explorer4x4.com/overhead.htm
Well you are done (lets hope). Put the key in the ignition and turn it and see if the console powers on and reads the temp properly (it will read 0 degrees if it isn't hooked up correctly).
Go find an abandoned parking lot and follow the following steps:
Press and hold the "MODE" button until you see "VAR" (takes around 5 seconds)
Release the "MODE" button. Push the "MODE" button until you have selected the zone you are currently in. (email me to find out your zone, I'll soon have a map up)
Release the "MODE" button and wait until the console is back at normal operation.
Press and hold the "MODE" button until you see "CAL" (takes around 9 seconds)
Release the "MODE" button.
Now the fun part. People will think you are crazy. Drive in a circle at around 3mph. Your console will be changing direction really fast. Continue to do this until the console is back at normal operations.
http://www.explorer4x4.com/overhead.htm
#7
#9
It was in the 1998 Ford Explorer's manual found here
http://www.genuineservice.com/genuin...ault?page=Home
It looks like you're in zone 3.
#10
Originally Posted by buzzair
It was in the 1998 Ford Explorer's manual found here
http://www.genuineservice.com/genuin...ault?page=Home
It looks like you're in zone 3.
Thread
Thread Starter
Forum
Replies
Last Post
Aragorn 2006 4.0 SOHC
General Ford Ranger Discussion
7
04-17-2014 10:00 AM
joshtank
Exterior Semi-Tech
1
08-30-2009 07:11 PM
benny
General Technical & Electrical
19
08-31-2004 10:54 AM