Passenger Map Light dosent turn on in any condition.
#1
#3
RF Veteran
iTrader: (1)
Bulb?
On a 2001 wiring diagram it shows Map 1 and Map 2 both connect to the same 12v line and both connect to the same ground wire inside the assembly.
The switch for each controls the Ground connection.
So with bulb removed there should be 12v but no ground unless switch is on.
I would use a volt meter to test for 12v at the socket and then an OHM meter to test if ground is present when switch is on.
On a 2001 wiring diagram it shows Map 1 and Map 2 both connect to the same 12v line and both connect to the same ground wire inside the assembly.
The switch for each controls the Ground connection.
So with bulb removed there should be 12v but no ground unless switch is on.
I would use a volt meter to test for 12v at the socket and then an OHM meter to test if ground is present when switch is on.
Thread
Thread Starter
Forum
Replies
Last Post
Outlaw123
2.9L & 3.0L V6 Tech
3
07-13-2015 10:10 PM
frontroyalva
OLD - Interior, Exterior, Electrical, & Misc.
0
04-11-2011 10:24 PM
044x4
4.0L OHV & SOHC V6 Tech
5
05-02-2010 02:39 PM