Tremor Cluster swap
#1
#3
#10
Cluster Not Working.....
Well went out to install my new cluster and guess what it doesn't work.
I guess the PCM does not send the ODOMETER reading to the unit.I plugged the new one in and it read 9000 miles vice my 35000 miles...
so guess need to ask if I switch the odometer unit from my current one to the new one it should work, right?????
Also looking into the LED mod before i install it again...
I guess the PCM does not send the ODOMETER reading to the unit.I plugged the new one in and it read 9000 miles vice my 35000 miles...
so guess need to ask if I switch the odometer unit from my current one to the new one it should work, right?????
Also looking into the LED mod before i install it again...
#12
#13
Did you take the needles off? I have had every single component of that cluster off - you can change the odometer but I don't see why that would help. If any information is stored on the cluster it is on the chip. Use your stock cluster and put the parts on that you want too.
I have extra white faces from a spare I bought, I don't know if I'll sell them on here or keep it as spare.
I have extra white faces from a spare I bought, I don't know if I'll sell them on here or keep it as spare.
#15
so basically reset my PCM??? I will try it tomorrow... think i will do the whole blue gauge face change and see if it works.... Anyone done just a color swap on the cluster vice leds??? DO they make direct replacement leds for the cluster????
#16
I bought thier needles for my cluster and thier products are good quality. Make sure if you are looking for needles that rusty gets you ones that will fit because the original 2004 needles that they sent me were too big and woulndt hold onto the shafts of the motors. Instead he is sending me GM needles that he says should fit much tighter.
From what I have looked at they sell a 'stainless steel' looking and an "aqua" looking face set for the ranger. I like my white gauges more so I'm not interested in those, however you might be.
Please search for relevant info on cluster mods before posting as there is a lot of good info on ranger-forums.
#17
JP7,
Had you read what i wrote instead of just jumping around...
I had asked if anyone if they had done just a color swap(scratch the green off and paint blue) instead of using leds(just use the stock white bulbs). Then I asked if they made stock replacement LED's. I had seen someone with them but they said they were too long in that post... and havn't seen an answer on the bulb type/part number for the shorter ones....
Had you read what i wrote instead of just jumping around...
I had asked if anyone if they had done just a color swap(scratch the green off and paint blue) instead of using leds(just use the stock white bulbs). Then I asked if they made stock replacement LED's. I had seen someone with them but they said they were too long in that post... and havn't seen an answer on the bulb type/part number for the shorter ones....
#18
Ford must've changed that for the newer models. My roomate swapped a cluster with a tach into his 2007 ZX3 and it was stored in the cluster, so it reads more than it actually has lol
Thread
Thread Starter
Forum
Replies
Last Post
J's Ranger
General Technical & Electrical
1
10-17-2011 04:30 PM
RangerNDog
OLD - Interior, Exterior, Electrical, & Misc.
9
10-21-2009 12:58 PM
edgeofthecliff
General Ford Ranger Discussion
9
07-29-2004 08:19 PM