2005 seats to 2004 ranger
#2
#3
Thanks, both are extended but 2004 is 60/40 seats while I want to put in 2005 seats. these seats are bucket seats with the center console bolted to the tunnel between the seats. there is no bracket or holes in my 2004 tunnel. Any advice? If I didn't really like my truck, I would drill mounting holes and use self tapping cap screws to mount the ctr console
#4
Thanks, both are extended but 2004 is 60/40 seats while I want to put in 2005 seats. these seats are bucket seats with the center console bolted to the tunnel between the seats. there is no bracket or holes in my 2004 tunnel. Any advice? If I didn't really like my truck, I would drill mounting holes and use self tapping cap screws to mount the ctr console
They'll fit just fine then but thats the only way you'll be able to mount the aluminum bracket to the floor. I'd just go with self tapping screws and then seal it from the underside. There's probably 4 marks on the stamped steel floor of the cab that show where the bracket should mount. For the front of the console, once the bracket is in place, you can use velcro on the front underside to hold it onto the carpet. 2 less holes to put in the floor.
I did this swap on my old truck and my current truck has an explorer full length console.
Thread
Thread Starter
Forum
Replies
Last Post
BlackRanger04
4.0L OHV & SOHC V6 Tech
17
12-09-2022 02:13 PM
Fordsarebadass4
General Ford Ranger Discussion
7
02-25-2013 01:11 PM
For Sale: Seats, seats, SEATS! NC
drppdyllwrngr
OLD - Interior, Exterior, Electrical, & Misc.
30
03-16-2010 07:38 PM