Something isn't lining up with my overhead console..
#1
Something isn't lining up with my overhead console..
Welp... Finally putting everything back together and something isn't right.
See pictures.
I have a gap in the rear from the ohc to the headliner...
It's hard with the how-to's because they never tell you exactly where to put the bracket, so I used the little lip of the brack to the edge of the roof. (if that makes sense)
Everything works on the ohc and I like it a lot however with the gap it looks like ***...
Has anyone run into this problem or a fix? Do I need to mount the bracket a little more forward or backwards..etc?
The fronts and sides appear to be perfect... but I don't understand what's going on with the rear.. when I push on it and tighen it against the bracket it won't go any further because it hits the bracket... Would taking the bracket off and bending it upwards then putting it back in pull the back up?
Thanks,
-Nigel
See pictures.
I have a gap in the rear from the ohc to the headliner...
It's hard with the how-to's because they never tell you exactly where to put the bracket, so I used the little lip of the brack to the edge of the roof. (if that makes sense)
Everything works on the ohc and I like it a lot however with the gap it looks like ***...
Has anyone run into this problem or a fix? Do I need to mount the bracket a little more forward or backwards..etc?
The fronts and sides appear to be perfect... but I don't understand what's going on with the rear.. when I push on it and tighen it against the bracket it won't go any further because it hits the bracket... Would taking the bracket off and bending it upwards then putting it back in pull the back up?
Thanks,
-Nigel
#2
Yeah mine looked like that too at first.
I had to stuff some of the cut headliner material back under the remaining headliner to help push it down. That sealed the gap on mine 100%. I read about it on a few of the install threads.
I was also able to slip the back of the bracket above the headliner to help push the headliner down to it..sort of sandwich it between.
May have to re-adjust the bracket some too (aka bend it).
EDIT: Rest looks great!
I had to stuff some of the cut headliner material back under the remaining headliner to help push it down. That sealed the gap on mine 100%. I read about it on a few of the install threads.
I was also able to slip the back of the bracket above the headliner to help push the headliner down to it..sort of sandwich it between.
May have to re-adjust the bracket some too (aka bend it).
EDIT: Rest looks great!
Last edited by logan03CO; 12-04-2011 at 04:15 PM.
#4
#5
#6
#7
#14
Thread
Thread Starter
Forum
Replies
Last Post
ranger4.0
OLD - Interior, Exterior, Electrical, & Misc.
10
02-15-2011 11:25 PM
TheBearJeweler
OLD - Interior, Exterior, Electrical, & Misc.
19
06-12-2009 07:26 PM