Hello all,

I was following this thread (rwenzig's wiring guide) and have run in to a snag...

Console Power: Grey/Yellow ---> White/Blue (white wire with blue stripe - truck radio harness)
Console Night Dim: Light Blue/Red or Red/Black ---> Blue/White (blue wire with white stripe - truck radio harness)
Console Maps: Green/Orange ---> Violet/Red (truck radio harness)
Console Dome: Black/Blue ---> Green/Blue (above truck's factory dome)
Console VSS: Grey/Black ---> Violet/Orange (pin #1 of the truck's center PCM connector)
Console Ground: Black ---> truck chassis ground

The 2 lines in red - Grey/Yellow to White/Blue and Green/Orange to Violet/Red are not in my 2010 radio harness. What is the 2010 year equivalent? I have a white and white/black and also a violet and violet/black.

Another, probably important question, am I tapping these directly into the radio harness or the wires going into the black box on the left side behind the radio?? And to make sure, I should only have 1 wire at the dome light in my 2010, correct?

Thanks,
Frank

EDIT:

Turns out if you pull the radio harness out even further, you find a second 'connection' to a new set of wires which has what I needed.

Also, my mirror fell off somehow, but the clip is still on the windshield. I can't get the mirror back onto the ball-socket thing.