A-Pillar Trim Removal
#1
A-Pillar Trim Removal
I have all but one piece of weatherstripping to replaced on the driver's side. This last piece requires the removal of the trim pieces. I was able to snap-off the floor trim piece, but can't figure out how the A-pillar trim is supposed to be removed. Does anyone know please?
#3
Yeah, if you have the pillar grab bars just remove them by taking off the two rubber guards on each one and unscrewing it. Then pull the pillar out. It has lil plastic tabs that "snap" into lil metal grabber things on the actual a-pillar of the truck.
Don't be afraid, just yank that trim peice off.
Don't be afraid, just yank that trim peice off.
#6
#7
Originally Posted by this_is_nascar
I was hoping to find the support brackets arleady in-place. If that's not the case, I won't worry about doing it. I can alwasy find the new trim piece and bar online or at a junkyard.
#8
Like I said, tomorrow when I get the trim off, if the mount is not already there, I'll bag the idea of installing the grab handles. For now, my main objective is to get that last piece of weatherstripping replaced. While I have the extended cab floor trim off, I'll knock a hole thru the drain-plug to run the CB coax. I'm tired of having it entering the cab via the rear sliding window.
#9
Originally Posted by this_is_nascar
While I have the extended cab floor trim off, I'll knock a hole thru the drain-plug to run the CB coax. I'm tired of having it entering the cab via the rear sliding window.
#10
Thread
Thread Starter
Forum
Replies
Last Post
Want to Buy: 2003 ford ranger pillar arm trim (CA)
bnoirot
OLD - Interior, Exterior, Electrical, & Misc.
1
12-29-2014 08:36 PM
Want to Buy: Ranger L & R pillar trim
Topdog2007
OLD - Interior, Exterior, Electrical, & Misc.
2
03-01-2011 11:19 AM