I should have done this a long time ago...
#1
#4
thx Ranger Guy. I need some advice on a torsion key leveling lift I did. Driver's side went fine. Pass side the bar came out of the control arm when I was banging the old key off with a hammer. I thought I installed it back where it was (I rushed due to time constraints in my buddy's garage and stupidly did not mark the position of the bar in the control arm). Later realized I must have indexed wrong. I tried to re-index incorrectly but the pass side still sits higher, is stiffer and the control arm doesn't want to budge if I drop the tire try to lift the control arm with a jack (realized this a few days ago installing new rancho 5000 shocks). How can I ensure it's indexed correctly? (there is no mark on the front of the bar due to beating the hell out of it with a hammer). This is driving me crazy!!! Please help!
Thread
Thread Starter
Forum
Replies
Last Post
cgerritsen
Member Introductions
12
09-20-2011 08:20 PM
JRanger
Member Introductions
12
11-19-2008 02:42 PM
marcos
General Ford Ranger Discussion
29
10-29-2005 10:47 AM