I am new to the site and would like to ask some advice. I have a 2004 4door Supercab Ranger Edge, it is a 4X2 ( I know wish I would have bought the 4X4 also but I interstate drive alot). Can you put a body lift on a 4X2 and would it look right? I would like to have it set up a bite higher and a more aggressive look. It has the stock 235/75/15's that are due to replace soon.

 

yes you can body lift your edge it will look good your better off putting spindle lift on it but body is cheaper. some 33x12.5x15 on some 15x8 or 15x10

and welcome

 

What he said ^^, and welcome to R-F as well!! Blades

 

Welcome to RF

 

welcome to the site

 

Welcome

Spindle and AAL would be soo much better than a BL

 

yea id say go with a spindle lift and AAL thats what im gonna do when i get the funds

 

Welcome to RF

 

Howdy Tom! Welcome to the site! Lift it,a body lift will be fine for looks purposes.

 

Any suggestions on the kit to purchase. I have the money just not the know how. How much do you think a lift will cost.

Thanks for the welcome!

 

um..i dont know much bout the 2wd lifting since im a 4wd but i know that fabtech makes a spindle kit for the rangers..and i think its like 300 maybe..or something in that range..

i know a body lift is like 245 AALs are bout 50

 

spindles are REAL easy to put on... hardest part is gettin the ball joints out... go to a shop that does lifts.. talk to an installer and tell him you will take him out to dinner n **** if he helps ya put the lift on, on the side. dinner or beer, you dont know what some ppl will do for a case of beer haha
welcome

 

Tomorrow I am going to get an ailiment and my T-bar cranked to level off the truck. Next step will be the tires I am guessing.

HighRoller II if my truck set like your's I would be happy!

 

Welcome!

I have a Fabtech Spindle Lift, larger blocks and a lift shackle, and a bit of torsion crank and I'm running 35's on my 2002, 4x2 Edge. I put an FX4 31 spline rear axle on, and a locker, and it offroads half-decently. Lots you can do with a 4x2 -- though I'm converting this to a 4x4 this spring with a SAS and so on.