PS needed ; Calling mustang scoop owners also!
#1
PhotoShop needed ; Calling mustang scoop owners also!
Ok guy I got a stick up my butt lately and I wonder what a mustang scoop would look like on my truck, I think I might do this, this summer. If people could Photo shop a scoop onto my truck I would be greatly happy!
ALSO COULD mustang scoop owners tell me HOW YOU put yours on. I know about the stock fasterns on the scoop but I just wanted to know how you people put YOURS on! thanks ALOT!!!!
I barrowed Slayenem's pics from this Thread because its also already silver
Here is a few of my truck but if they dont work look into my cardomain there is about 170 pics there
ALSO COULD mustang scoop owners tell me HOW YOU put yours on. I know about the stock fasterns on the scoop but I just wanted to know how you people put YOURS on! thanks ALOT!!!!
I barrowed Slayenem's pics from this Thread because its also already silver
Here is a few of my truck but if they dont work look into my cardomain there is about 170 pics there
Last edited by Redneckstone; 03-08-2005 at 06:46 PM.
#3
I used the stock bolts. There use to be a good how to at www.fordcustoms.com, but its gone.
Cliff notes of what I did:
-Put tape all over my hood
-trimmed off some of the pin mount locations (I can't remember exactly what I did, but I just use a dremmel tool)
-Make a poster board template of the bolt holes needed
-tested the hole locations on a piece of plywood
-Located the center on the hood and poster board
-removed under hood shield
-drilled small holes according to the poster board
-use a hole say on the under side hood bracing where the nuts go
-tried to make a template for the scoop. Mine turned out ok, but not perfect
-cut scoop on band saw
-install scoop and hood liner
Cliff notes of what I did:
-Put tape all over my hood
-trimmed off some of the pin mount locations (I can't remember exactly what I did, but I just use a dremmel tool)
-Make a poster board template of the bolt holes needed
-tested the hole locations on a piece of plywood
-Located the center on the hood and poster board
-removed under hood shield
-drilled small holes according to the poster board
-use a hole say on the under side hood bracing where the nuts go
-tried to make a template for the scoop. Mine turned out ok, but not perfect
-cut scoop on band saw
-install scoop and hood liner
#5
#9
Originally Posted by TractionBound
I would, but im too lazy... looks good...
p.s. Robin has a template he can send you.
p.s. Robin has a template he can send you.
#10
#13
Originally Posted by Diabolic
I tried doing an angle PS but it didn't turn out well because both trucks are at slightly different angles.
WELL GUYS!!!!!!!!!!!!! I am currently Biddin on a mustang scoop that is the same COLOR CODE as my truck so no painting even!!!!! must be fate!!!!
Thread
Thread Starter
Forum
Replies
Last Post
Mike9825
General Ford Ranger Discussion
15
09-17-2006 11:19 AM