351w ranger
#1
351w ranger
Well i have been wanting to do this build for a good little bit now. I just picked up A 96 ford ranger x cab step side black splash . the motor will be a ford 351w out of my old 95 ford bronco. So far i have yanked the motor and trans from the ranger. Got the 351w torn down. And hopefully i can get it back from the machine shop soon. today i got my fuel cell mounted. and tomorrow i will start to rip out the old wiring harness and start to rewire it.
Motor specs
351w roller motor with .030 over forged pistons.
stock crank and eagle I-beam rods.
holley 750 carb
Msd billet dis
Msd street streep ignition box
Edelbrok air gap intake
Ford GT40 heads
EZ wiring wire harness
think i may change my mind and go with a c4 instead of a t5
8.8 rear
oh and just a little shot to it too lol
Scott
Motor specs
351w roller motor with .030 over forged pistons.
stock crank and eagle I-beam rods.
holley 750 carb
Msd billet dis
Msd street streep ignition box
Edelbrok air gap intake
Ford GT40 heads
EZ wiring wire harness
think i may change my mind and go with a c4 instead of a t5
8.8 rear
oh and just a little shot to it too lol
Scott
#5
Sory i have never updated this i have been busy with work.Well i got my block back i eneded up going a diffrent route. Well its all forged and troked to a 408 and got a set of AFR's and a c4. Rewired the whole truck from front to rear and made a a new instrument panel. it is coming along still need to get some parts tho. Just NO time to work on it tho. well here are some picks
#8
Thread
Thread Starter
Forum
Replies
Last Post