View Full Version : 4.0L OHV & SOHC V6 Tech
Pages :
1
2
3
4
5
6
7
[ 8]
9
10
11
12
13
14
15
- exhaust question
- Dumped my exhaust
- Spark Plug Gap
- Check Engine Light
- 4.0 OHV vs 4.0I6HO
- misfire..... again
- Hit a phone pole, need your help!
- I'm Impressed
- Programmers
- compresion test #'s
- Flooding when starting
- need help hot wiring a 4.0 ohv
- Vacuum Leak???
- HELP, truck won't start!
- Problem with gauge
- what tuner?
- Ordering a tuner
- max rpm
- upgrading air intake
- adding exhaust
- Is every 4.0 noisy?
- max hp from xcal
- Dual Exhaust magnaflow
- Serpentine belt. Tighten?
- starter problems help please
- Got the Borla installed
- Harmonic balance woes
- Put my air intake in this weekend!!
- Good "pulling" exhaust?
- my truck is retarded...
- 4.0 engine bay (pullies and belt rant)
- .054 Whats your spark plug gap?
- .054 Whats your spark plug gap?
- 2000 4.0 OHV swap to 4.0L SOHC
- Ordering a programmer soon
- Rattling noise from engine after oil chane????
- Got a new Ranger
- overdrive blinking
- Quik Question
- Intake question...
- Terminator!
- so my x-cal is on its way, few questions
- How-To: Eliminate 4.0 SOHC 'jolt/buck' symptons
- block heater location?
- Another CAI question
- bad day need help
- Which magnaflow
- cherry bomb?
- A simple question.
- Fastest MPH's in your 4.0's
- FlowTech Warlock Bypass Muffler
- SOHC 'jolt' at cruising speed
- 4.0 sohc head gaskets
- Changed my plugs
- after riding in my truck, my buddy wants to swap in a 4.0
- shock emergency
- exhaust tips
- Belt Size
- AIR FLOW AND EXHAUST
- magnaflow ?
- Exhaust pic needed
- Bigger tires= lower rpm?
- Changing spark plugs with no lift??
- worse mpg with 93 octane
- Fuel system issues
- Ford Seafoam Questions.
- check engine
- Possible bad intake gaskets??
- Tank size?
- Vacuum Cap?
- I Was Bored.......
- exhaust?
- upper rad hose
- Muffler size
- 4.0 - 2.9 oil pans,same?
- cheaper than K&N, same filter
- Broken E-brake Cable.
- Need Help Bad!
- Thrush fully welded vid pleaseH
- WORST 4.0 mileage
- X-Cal tuner
- gas pedal vibrates...
- help
- 4.0 Sohc Mpg
- Just hit 100k...
- 98 Explorer throwing codes
- cleanin my maf?
- Fuel filter...
- Summit intake?? OHC
- P1000 code.. Need help!
- '03 4.0 vs '05 up 4.0
- 4.0 OHV out of a 93 in my 86?
- Losing coolant and fouling spark plug
- 4.0 skip/misfire/bucking
- Randomly wont start??
- Underdrive pulleys
- running lean codes and stalling
- Xcal or chip ?
- help! i went one puddle too far...
- 4.0 ohv intake porting
- Help Please
- valve covers!
- exhaust ?'s
- What to buy
- Squeaky Belt! AHH!
- Recall?
- 4.0 OHV t-stat.
- Long Tubes
- Exhaust Types
- Help truck wont start
- noise from the pulleys
- Error Codes/MAS issue?
- Oil In Filter?
- Awkardly long cold starting
- Help!!
- Loss of Power, Sounds like Vacuum Leak
- Transmission
- Engine running rough, spark plugs?
- first gen 2.3 to 4.0 swap
- cut off tail pipes?
- Got my truck back from the mechanics.
- abs sensor?
- Mildly Rouh Idle?
- exhaust question-rear 02 sensor/simulators
- I'm stumped?! Trouble Codes
- ABS problems
- Fuel injector operating voltage?
- 1997 4.0 OHV rough idle @ 86,991 miles / 140,000k
- question about the 4.0L V6 5 speed manual
- Idler Pulley Question?
- Truck wont start!!
- What to get!!!
- Is this the same??
- squeaky??
- Screamin Demon, Plugs, and Wires
- NGK Iridium plugs
- Lifter?
- 98 4.0 OHV MAF Mod, rough idle
- Help with seafoam
- Trans Question??
- 3.0 to 4.0
- EGR Tube Cutting
- Throttle Cable Mod-- A Different Way?
- P0171 Code. . .need a little help
- millage randomly got REAL BAD
- oxygen sensor
- a few exhaust thoughts
- high flow cat?
- Finally drove a newer 4.0L V6-a 2008! -IMPRESSED
- What year OHV's are the same?
- runnin lean
- help me spend my money!
- What does a throttle body spacer do?
- 4.0 OHV Performance?
- Strange cold start issue.
- 4.0 sohc/5speed high idle sometimes
- Thermostat Advise
- check engine
- which muffler?
- No more squeeling belts
- What can I expect from this Mod
- Xcal2. will it compensate for power loss from 32" tires?
- Cut my cats?
- seafoam question
- More MAF problems.
- exhaust dilemma
- jet mass air flow sensor
- interesting sound coming from flowmaster 40
- Mileage Crapper
- K & N FIPK completely F'ed my MAF sensor.
- Exhaust questions
- cam question
- Fuel Economy.. Stats (PICS)
- Wheel Bearing/Hub Assembly
- are 4.0 headers interchangeable?
- How hard is it to....
- Performance time
- Another Borla muffler thread...
- Rough Low Idling!!!
- Idling issues and dieing.
- Replacing heads...
- High Idle
- Help the College Kid out
- Put my intake in
- New Top end..
- Places to buy a used 4.0 motor?
- 0-95mph video
- 4.0 OHV Auto, Running cold? Poor Gas Mileage.
- 4.0 rebuild woes
- true cold air/ ram air
- tires and gas milage
- Not sure what was wrong?
- muffler opitions
- louder exhaust
- brakes locked up when trying to reverse
- 1993 4.0 4x4 Ranger x-cab...
- Idle learning steps?
- Two Different Plugs in my 4.0??
- Ranger at work.
- Engine mod checklist
- blown head gasket
- 93' 4.0 swap with 2001 4.0???
- O2 sensors
- Picking up my CIA today
- Intermitent Code 117
- Time for upgrades
- Hensen 92 octane tune is pinging
- ECU CEL questions.
- Emissions
- Spark plug wires
- 4.0L Throttle Body from mustang to a ranger
- Engine Swap
- Prefilter Cover
- upgrades for engine?
- Vortex Muffler
- Oil leak... Help..
- 4.0 SOHC milage
- Ask me tuning questions
- rev limiter
- want my truck fast
- HELP!! Injectors..
- exaust
- Oversized pulleys???
- Pacesetter Headers
- PO141 code
- high flow cats
- Exhaust help - Straight piping
- Canister Purge Valve
- Fuel Economy
- Budget Ranger Build...
- got a "chip" in my 4.0
- EGR piping..stuff
- Need Help Water Leaking Into Cab
- Can someone verify this for me?
- 4.0 ohv intake manifold question
- starater went
- polishing the throttle body
- Underdrive Pulley Install Help
- Help!! Gas Mileage....
- Oil leak!
- need help with magnaflow..soon
- Vibration...
- coolant change
- auto to manual tranny swap
- Dimensions
- Oil, I need help
- first p0401 (new DPFE), now p0402 (new EGR)
- squeaking and stalling
- Screamin Demon Coil VS. Accel
- Running very bad...engine codes P0172 & P0175
|
|
vBulletin® v3.8.7, Copyright ©2000-2013, vBulletin Solutions, Inc.
SEO by vBSEO ©2010, Crawlability, Inc.