Goin Deep!!!
#1
Join Date: Jan 2008
Location: Elberton, GA
Posts: 695
Likes: 0
Received 0 Likes
on
0 Posts
#3
Join Date: Jan 2008
Location: Elberton, GA
Posts: 695
Likes: 0
Received 0 Likes
on
0 Posts
I would love to organize a meet. Between me you and trigger01 we need 2. I am game for durhamtown any sat. or sun. and i got some friends that would definitely come along. I just wish alot more members would come. Last time i tried to organize 1 no one could come. Yall organize it and ill def. try 100% to be there.
#4
#5
#8
Join Date: Jan 2008
Location: Elberton, GA
Posts: 695
Likes: 0
Received 0 Likes
on
0 Posts
yea i took that tool box off of my old truck and just havent got the $ right now to get a black one.
I extended my diff. breathers well above that. Front diff. breather is higher than the battery and rear diff. breather is above the gas door. Im not worried about it.
I extended my diff. breathers well above that. Front diff. breather is higher than the battery and rear diff. breather is above the gas door. Im not worried about it.
#11
Join Date: Jan 2008
Location: Elberton, GA
Posts: 695
Likes: 0
Received 0 Likes
on
0 Posts
#14
To extend them just go get 4 feet of 1/4" ID fuel line hose and a few universal vacuum line connectors from Advanced Auto or wherever. Put the connector into the original hose then put the new line on the other end of the connector and run it where you need it then cut the line there than do the same on the other breather tube. I used liquid tape to seal the outside of the lines to the connectors just in case. The front I ran to the black box above drivers side tire. The rear I ran to the fuel filler. The t-case was a little harder to get to but ran it to the same place as the front diff tube. I have yet to get to the tranny breather tube since thereis no room for me to get my hands, much less a clamp and tool in there. I will be able to get the tranny tube on after I get the lift on tomorrow.
Thread
Thread Starter
Forum
Replies
Last Post
LowMaz
General Ford Ranger Discussion
16
06-21-2007 06:38 PM