Well got it all finished up today! Was a little less plug and play than I thought. Had to get an entire wiring harness from the driver side up under the dash that runs along the driver side to the rear. Also had to get a new wiring harness for the driver door. Seems that no two things that I would have guessed should be compatible were. Had to get it all out of the same year ranger. Took a total of 4 days working one step at a time. Ran into a couple glitches but all is done and good now! Have two keyfobs and it sure is nice!
There is one con however.....every time I go to burger king I keep grabbing for the window crank to roll it down HAHAHAHAHA. Gonna have to get used to this! Here are some pics. Will have more soon!
Factory harness that runs along driver side floor to the back of the truck. That Big gray box plugs in under the dash
Whole harness that had to be removed. Was a PITA. Had to take the E-brake off to get this thing out.
Keyless entry module. Found on the back wall in between the two jumper seats on the 4 doors. I tucked mine out of the way behind the driver rear jump seat.
Here it is tucked away.
Gonna get some caps for the holes. Not about to pay $50 a piece for a whole new door panel from the yards!!!
Driver side all done.
More pics to come soon of the rest of the install!!!