Coilover Conversion: Support Bar and Limit Strap Set-up
#1
#12
From the looks of it, it's VERY similar to the RCD stuff. Bolt on brackets to the trans x-member and I assume bolt-on to the Superlift rear x-member whereas RCD has brackets built into their rear x-member.
I will likely do these when I do my swap sometime next year.
Looks good KLC! Are these the ones that Jake sold...or???
I will likely do these when I do my swap sometime next year.
Looks good KLC! Are these the ones that Jake sold...or???
#14
Thanks everyone!
Sure thing, I'll get one this afternoon.
Yes, the design is very similar to the RCD set-up. And, yes, Jacob made them, but I "refined" them for my satisfaction, i.e. welds, cuts, paint, etc.
From the looks of it, it's VERY similar to the RCD stuff. Bolt on brackets to the trans x-member and I assume bolt-on to the Superlift rear x-member whereas RCD has brackets built into their rear x-member.
I will likely do these when I do my swap sometime next year.
Looks good KLC! Are these the ones that Jake sold...or???
I will likely do these when I do my swap sometime next year.
Looks good KLC! Are these the ones that Jake sold...or???
#15
#16
#19
Not sure who you are asking, but very good. Much better than stock, even with a lift.
Thread
Thread Starter
Forum
Replies
Last Post
ecrase2500
Suspension Tech
15
11-15-2015 08:03 AM
btm757
OLD - Suspension, Tires, & Wheels
10
02-07-2014 05:22 AM
shooterdude199
Snapshots
17
09-27-2011 02:25 PM