quads atvs in a stepside
#2
#3
#5
I don't have any pics or a stepside but my 400ex is only about an inch too wide to fit the front wheels between the wheel wells. I also have a bedliner and that is why it won't roll between the wheel wells. I just lift it up over them and shut the tailgate. not sure if that answers anything.
#6
_/ \_ -------
If that was the wheel well the line next to it is the nerf bar. it dosen't work out too well
Its a crude drawing, but it works.
#8
#9
#12
we couldn't fit my friends suzuki ltz450 in a stepside ranger we had to have one side on the bed rail so we took it and looked like \
that must be one of the smaller raptors. theres no way you can fit a large one in a steppie without putting one side wheels on the bedrail
EDIT: i was right.
dave you wont fit anything larger than a 250 in there unless you put one side tires on the bed rail lol they'll be too wide
that must be one of the smaller raptors. theres no way you can fit a large one in a steppie without putting one side wheels on the bedrail
EDIT: i was right.
dave you wont fit anything larger than a 250 in there unless you put one side tires on the bed rail lol they'll be too wide
Last edited by 99offroadrngr; 03-25-2011 at 10:35 PM. Reason: LURKED
#14
#15
i do wish it had a little more top end but that can be fixed with some mods. personally i wished i would have went with a yfz450 but since it fit in the bed i couldnt pass it up
Thread
Thread Starter
Forum
Replies
Last Post