SOHC - 2.3L & 2.5L Lima Engines Discussions and Topics specific to the Lima 4 cylinder engines

1987 2.3 idle problem...need help

Thread Tools
 
Search this Thread
 
  #1  
Old 06-08-2011
87ranger2wd's Avatar
Member
Thread Starter
Join Date: Jun 2011
Location: Citrus Heights CA
Posts: 5
Likes: 0
Received 0 Likes on 0 Posts
1987 2.3 idle problem...need help

ok, so i bought this 87 due to someone took good care of it, it has an msd coil pac distributor and wires, k&n filter, custom wheels and all news 5 spd trans and clutch, brand new exhaust...however someone tried to steal it and tore up interior, but that isnt the issue the issue is it passed smog under a year ago with previous owner and now i have to smog it but on a cold start it fires up first crank and runs fine, 30-45 seconds the idle goes up a little. another 30-45 it goes higher and higher to which i rev it and it come down to idle, the truck idles for 30 -45 seconds before it starts to miss fire and wanna die. the engine will rev itself and stay lit but this keeps going on and on and on, if i stop at a light it feels the idle is too low and it will occasionally die but will fire right back up with the first crank. im totally lost on what is causing it cause im getting 24 mpg on average and the timing reads 20 degrees on the balancer. ive put in a new temp sensor and iac neither of which did anything unless i somehow got a bad iac from duralast. i bought this truck for work and play but im at my end with this thing, If it dont pass smog and run right i dont want it does anyone have a clue to what might be my issue?
 

Last edited by 87ranger2wd; 06-08-2011 at 03:48 PM. Reason: spelling
  #2  
Old 06-08-2011
OTRtech's Avatar
Member
Join Date: Mar 2007
Location: Upstate,NY
Posts: 2,598
Likes: 0
Received 11 Likes on 11 Posts
Check the butterfly shaft on the throttle body for any up/down , side to side play.
Also check the throttle plates where they contact the bore to see if they have worn a groove in it . It may be leaking vacuum in these areas.
 
  #3  
Old 06-08-2011
87ranger2wd's Avatar
Member
Thread Starter
Join Date: Jun 2011
Location: Citrus Heights CA
Posts: 5
Likes: 0
Received 0 Likes on 0 Posts
ok, i checked for regular vaccuum leaks with throttle body cleaner buy didnt notice any of those issues ill take a look and let you know
 
  #4  
Old 06-08-2011
87ranger2wd's Avatar
Member
Thread Starter
Join Date: Jun 2011
Location: Citrus Heights CA
Posts: 5
Likes: 0
Received 0 Likes on 0 Posts
checked and cant find any leaks around throttle, however the idle screw isnt touching the throttle cable, i know your not supposed to adjust them on fuel injected cars but could this one be turned in without killing my smog?
 
  #5  
Old 09-16-2011
chilsam's Avatar
Member
Join Date: Mar 2011
Location: chillicothe il
Posts: 23
Likes: 0
Received 0 Likes on 0 Posts
87 Idle

Did you ever figure it out mines doing the same thing.THANX!
 
  #6  
Old 10-08-2011
chilsam's Avatar
Member
Join Date: Mar 2011
Location: chillicothe il
Posts: 23
Likes: 0
Received 0 Likes on 0 Posts
EMTS sensor

I replaced it and it works GREAT now,it's in the intake manifold.Hope this helps.
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
tf79
SOHC - 2.3L & 2.5L Lima Engines
1
10-27-2013 03:40 PM
david.kraft18
General Ford Ranger Discussion
3
02-14-2013 12:02 PM
j_huhnke
4.0L OHV & SOHC V6 Tech
2
03-25-2012 09:26 AM
4door
2.9L & 3.0L V6 Tech
7
12-16-2010 11:49 AM
tluafeD
General Technical & Electrical
12
03-21-2010 02:07 PM



Quick Reply: 1987 2.3 idle problem...need help



All times are GMT -6. The time now is 05:58 AM.