2/4 drop on Gen 3...info needed - Ranger-Forums - The Ultimate Ford Ranger Resource
Ford Ranger Forum - Forums for Ford Ranger enthusiast!

Go Back   Ranger-Forums - The Ultimate Ford Ranger Resource Arrow Ranger-Forums Technical Forum Arrow Suspension Tech

Suspension Tech General discussion of suspension for the Ford Ranger.

LinkBack Thread Tools Search this Thread
Old 01-31-2009
Thread Starter

I am: Scott Ozanne
Join Date: Jan 2009
Location: Loveland, OH
Vehicle: 1997 Ford Ranger
Posts: 5
Total Props: 0
Icon5 2/4 drop on Gen 3...info needed

My truck is a 1997 2wd/4cyl/5 speed/reg cab & bed and has the 7.5" rear axle. I am thinking of doing a rear flip kit with Hardbody rear shocks and 2" drop coils in the front and was wondering how it will sit. I am concerned that the rear will sit lower then the front with the flip and coils as most pictures of 3/4 drops I have seen the trucks look level. I was going to combine Belltech 6700 1" drop shackles after the flip because I really am only looking for a 2/3 drop. I like the rear slightly higher. Right now the rear end sits about 2.5" higher than the front. That is why I was going with that setup. When you do the flip kit how close to 4" does it lower the rear? Anyone here have pictures of Gen 3 Rangers with a 2/4 drop? Thank you for any help/guidance.

Last edited by modular; 01-31-2009 at 10:50 AM.
Reply With Quote
+ 0 -
Old 01-31-2009
gumby's Avatar
iTrader: (1)
I am: gumby damnit!
Join Date: Nov 2005
Location: indy
Vehicle: 93 xlt
Posts: 1,581
Total Props: 0
it will most likely sit low in the rear with 2" coils and a flip kit. my 93 sat low in the rear with beams and a flipkit. each truck is slightly different though.

id have the shackles ready in case you need them.
Reply With Quote
+ 0 -

Similar Threads
Thread Thread Starter Forum Replies Last Post
replaced my gen 3 tails with gen 4 tail assy's racsan Exterior Semi-Tech 1 04-05-2011 08:50 PM
OHC needed adn info needed plz help OneTireFire General Ford Ranger Discussion 3 04-15-2010 06:34 AM
3rd gen bed onto 2nd gen pepps Exterior Semi-Tech 29 06-20-2009 10:58 PM
Can a Gen I body fit on a Gen IV + frame? HAZZARDJOHN New Ideas 1 05-23-2009 08:50 PM
bed swapping...2nd gen with 3rd gen? deathbypsi General Ford Ranger Discussion 5 03-17-2009 02:12 PM

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

All times are GMT -6. The time now is 07:08 AM.