2002FX4's SAS thread
#27
#30
Originally Posted by gumby
will these be youre finished ride height measurements?
what size is the new wheel/tire combo?
lookin good.
edit. also, what kind of rear bumpstops are those?
what size is the new wheel/tire combo?
lookin good.
edit. also, what kind of rear bumpstops are those?
#32
#34
#35
Originally Posted by ranger
ill definitly want you to show me. when do you think it will be finished?
Up front I finally ground down all the shmada left from the old suspension that was removed, so the frame rails are nice and clean and ready for the steering componentry to be figured out and done. That's really the only area untouched at this point. Tomorrow is set for the header install. Then the area will be ready for steering, and finally the shock hoops. Both axles are ready to be put in place for shock tabs. The front drive shaft is currently being lengthened w/a long-travel kit.
When all is in place, axles and whatnot are painted, then its onto the lift for gears, clutch, (probably do the traction bars then, too) and whatever else to be finished up.
#37
Originally Posted by Gearhead61
This could be the SAS with the LEAST pictures on the site! That needs to change!
Haha I'm just playing man... what are you doing for steering? The progress so far looks awesome!
Is it just me though or is your tire going to rub on your front bumper?
Haha I'm just playing man... what are you doing for steering? The progress so far looks awesome!
Is it just me though or is your tire going to rub on your front bumper?
#38
#40
Originally Posted by Gearhead61
This could be the SAS with the LEAST pictures on the site! That needs to change!
Haha I'm just playing man... what are you doing for steering? The progress so far looks awesome!
Is it just me though or is your tire going to rub on your front bumper?
Haha I'm just playing man... what are you doing for steering? The progress so far looks awesome!
Is it just me though or is your tire going to rub on your front bumper?
I know you're just playing though!
#46
#49
Originally Posted by gumby
der, sorry. i didnt even look at the future mods part of the sig. i saw the 35's in the current section and glazed the rest.
thanks for the info on the taller bumpstops. ill be in the market when i ditch the factory block and go to chevy leafs.
thanks for the info on the taller bumpstops. ill be in the market when i ditch the factory block and go to chevy leafs.
not sure if this will work with your setup, but heres what Bob did
https://www.ranger-forums.com/forum2...ighlight=chevy