RCD Measurements Please!
#1
#4
#5
#7
Originally Posted by whiteo5xlt
B and D are pointing at the holes where the t-bars used to go so they should be the same. the middle of it is 4 more inches higher
Last edited by 4x404Edge; 12-02-2007 at 10:49 AM.
#8
Ok i think im getting myself confused. Does anyone have a better picture of the front of a RCD lifted ranger that is more straight on. When i look at the picture it looks like A & E sit a lot higher then B & D but when whiteo5xlt measured it's actually lower to the ground....im not sure how that makes sense????
Im just trying to figure out how much ground clearence there is at those 5 locations with the RCD lift and 33 inch tires.
Im just trying to figure out how much ground clearence there is at those 5 locations with the RCD lift and 33 inch tires.
#9
#11
Originally Posted by 4x404Edge
OK i found a better pic that shows the front end of the RCD Kit. I see how A & E sits lower now that i have the better pic that is more straight on and not at an angle. Can a few more people measure theirs so i can compare numbers. Even if you have larger then 33 inch tires!
[IMG][/IMG]
[IMG][/IMG]
mmkay...
A-11.5
B-12
C-14
D-11.75
E-11.5
bam there yah go..
#13
#15
Originally Posted by 4x404Edge
Im not really fond of those rather large wheels but dammm is that one bad a** truck. How is the front differential and all holding up to those 37 inch tires?
its holding up good..had to replace one wheel bearing thats it..i dont wheel just normal street driving and parking it in parking lots for shows...runnin 4.88 gears so my acceleration is right on..running xcal2 programmer so its even better getting bout 13 mpg and 15 on highway..so i cant complain..
#16
Originally Posted by HighRollerII
thanks man..
its holding up good..had to replace one wheel bearing thats it..i dont wheel just normal street driving and parking it in parking lots for shows...runnin 4.88 gears so my acceleration is right on..running xcal2 programmer so its even better getting bout 13 mpg and 15 on highway..so i cant complain..
its holding up good..had to replace one wheel bearing thats it..i dont wheel just normal street driving and parking it in parking lots for shows...runnin 4.88 gears so my acceleration is right on..running xcal2 programmer so its even better getting bout 13 mpg and 15 on highway..so i cant complain..
Thread
Thread Starter
Forum
Replies
Last Post