Coilover Conversion Hardware
#484
Join Date: May 2006
Location: Boerne, TX
Posts: 1,997
Likes: 0
Received 0 Likes
on
0 Posts
sorry man. been in austin away fromt he comp. on the lowers, use 3/8" for the small holes. and on the uppers, use 1/2" bolts. i have a list of exact size lengths around here somewhere. ill get em and post them up for you.
#485
Member
iTrader: (2)
Join Date: Aug 2008
Location: Loxahatchee, FL
Posts: 1,825
Likes: 0
Received 0 Likes
on
0 Posts
ALL DONE!! sorry no pics yet. mallory took a bunch but i need her card adapter and its at her place. maybe shell email em to me when she gets home. went in ok. lil tougher than i expected thats for sure. Havent tweaked them or cranked them yet. havent even drivin it yet. I will in a bit im just too damn tired this sec.
#486
Join Date: May 2006
Location: Boerne, TX
Posts: 1,997
Likes: 0
Received 0 Likes
on
0 Posts
ALL DONE!! sorry no pics yet. mallory took a bunch but i need her card adapter and its at her place. maybe shell email em to me when she gets home. went in ok. lil tougher than i expected thats for sure. Havent tweaked them or cranked them yet. havent even drivin it yet. I will in a bit im just too damn tired this sec.
PICS OR GTFO!
#488
I have to ask this again... Is there any other hardware we need to do this installation besides what comes in the "kit"? Bolts for example? do the bolts go through the eyelets in the shocks, or do we need bushings for them? I want to be totally ready when i get my stuff!
???
#489
ALL DONE!! sorry no pics yet. mallory took a bunch but i need her card adapter and its at her place. maybe shell email em to me when she gets home. went in ok. lil tougher than i expected thats for sure. Havent tweaked them or cranked them yet. havent even drivin it yet. I will in a bit im just too damn tired this sec.
#492
Join Date: May 2006
Location: Boerne, TX
Posts: 1,997
Likes: 0
Received 0 Likes
on
0 Posts
dude when i originally made these, i was told that fox coilovers were 1.5" inches in width with the misalignment spacers. and thats what mine are. so i made them 1-5/8" in width to allow for a little bit of play then you can crank down on them and lose that 1/8". anyway, putting caseys on the other day, i found out that yalls new fox's are 1-1/4". so we had to put 2 washers on each side of the misalignment spacers. kinda sucked but it worked...
Last edited by shadow905; 10-26-2009 at 02:08 PM.
#497
HOW MUCH!?!!? Shouldn't be more than $10. My entire Superlift bolt kit was about $25....all were grade8 and it was probably somewhere near 40 fasteners.
#499
dude when i originally made these, i was told that fox coilovers were 1." inches in width with the misalignment spacers. and thats what mine are. so i made them 1-5/8" in width to allow for a little bit of play then you can crank down on them and lose that 1/8". anyway, putting caseys on the other day, i found out that yalls new fox's are 1-1/4". so we had to put 2 washers on each side of the misalignment spacers. kinda sucked but it worked...