installing spindles - ball joint separator
#1
#6
I rented one from AutoZone but I hit the spindle with a hammer and it came loose. I also used a hammer to get the ball-joints out, but I had to use a press to get it back in. I hope you have tires to put on that lifted truck, or its gonna look like mine right now, really stupid. You will be really suprised how much lift the spindles give you. Installing the spindles is not that difficult if you have the right tools, like a breaker bar and some good sockets. I used some cheapo sockets and a 3/8" rachet and broke the rachet.
JB
JB
#10
Originally Posted by jrpro130
i know i'm off topic...
how about snugging 35's under there??? or is that a no-go
how about snugging 35's under there??? or is that a no-go
I used a 3-arm gear puller to get my lower ball joints out. I had already removed the upper balljoints though... might have worked out easier if I'd done the lowers first?
#14
Thread
Thread Starter
Forum
Replies
Last Post
Marko2Ranger
Suspension Tech
17
12-30-2007 01:21 PM
zabeard
Suspension Tech
20
04-11-2007 08:36 AM