[serialkiller]

I installed a DJM Flip Kit on my 92 Ranger 2.3. After I was done I was looking at it, and on the drivers side it is about 2 inches lower then the passenger side. I know the Ranger lean but I thought that was just up front. I mean there isnt that much gas in it so It shouldnt be that low. On the passenger side I can put my hand between the tire and the fender. On the drivers side I cant at all. On the passenger side there is about 2 1/2 inches of clearance to the axle on the Drivers there is about 1 inch. I dont know if I put one side on wrong or something. Please some suggestions before I just put it back the way it was. Serial

[TheForce02]

first- did you drive it around and let things settle in???

[serialkiller]

I havent let it settle But I dont want it that low on the drivers side. I have seen alot of Gen 2 rangers with a 3/4 and the end isnt that low on either side. I am gonna check it out tomarrow. I must have did something wrong on one side. It shouldnt be tucking like 3 inches of tire with a 4 inch drop.


Serial

[thelowranger]

Did you use blocks at all? If so are they "seated" right?